Nickel wire

[Redhatcode29]

hi guys,

I am wondering on as to the gauge of the nickel wire, which i should use for a lemo2....also the number of wraps i should make.

Thanks.

 

[Katmar]

Bump

 

[suprtrkr]

I use both 28 and 32. For wraps I depend on Steam Engine.

 

[Hans Wermhat]

Coil wrapping | Steam Engine | free vaping calculators
Check the minimum output of your mod. My ipv4 won't fire below .12ohms in TC mode. I bought 28G wire and it takes about 12 wraps to get the resistance up that high with nickel. You might want to go with a smaller gauge wire depending on your mod's abilities.

 

[Redhatcode29]

Coil wrapping | Steam Engine | free vaping calculators
Check the minimum output of your mod. My iPV4 won't fire below .12ohms in TC mode. I bought 28G wire and it takes about 12 wraps to get the resistance up that high with nickel. You might want to go with a smaller gauge wire depending on your mod's abilities.

Hi, thanks for your reply. The mod which i am using is evic vt....thus, which gauge do you think is suitable for me...

 

[Hans Wermhat]

Features and Specs:

• Dimensions: 3-1/4"L x 1-7/8"W x 1"D (eVic-VT battery)
• Capacity: Built in 5000mAh battery
• 510 threaded
• Output mode: VT-Ti/VT-Ni/VW Mode
• Temperature Range: 100-315 Celsius /200-600 Fahrenheit
• Operating Wattage: 1 to 60 Watts
• Output Voltage: 0.5V-8.0V
• Resistance Range: 0.05-1.0ohm for VT mode
• Resistance Range: 0.15-3.5ohm for VW mode
• Charged via USB
• 4ml Capacity
• 510 drip tip compatible

Looks like it will fire down to .05ohms. You should be good with anything 28G or smaller. A single coil, 5 wraps @ 2mm ID will get you there.

 

[Redhatcode29]

Features and Specs:

• Dimensions: 3-1/4"L x 1-7/8"W x 1"D (eVic-VT battery)
• Capacity: Built in 5000mAh battery
• 510 threaded
• Output mode: VT-Ti/VT-Ni/VW Mode
• Temperature Range: 100-315 Celsius /200-600 Fahrenheit
• Operating Wattage: 1 to 60 Watts
• Output Voltage: 0.5V-8.0V
• Resistance Range: 0.05-1.0ohm for VT mode
• Resistance Range: 0.15-3.5ohm for VW mode
• Charged via USB
• 4ml Capacity
• 510 drip tip compatible

Looks like it will fire down to .05ohms. You should be good with anything 28G or smaller. A single coil, 5 wraps @ 2mm ID will get you there.

Hi, thanks for your reply, 5 wraps is it.... Ok will give it a try. I thought that nickel wires need up to 12 wraps! Ddnt know i only need 5...

 

[Hans Wermhat]

That's the minimum to get you up to the lower ohms limit. You can always wrap more.