I'm new to this forum, 2 weeks new to e-cigs, but 2 weeks off of real cigs!
I was going to reply to a question about this but since i'm a newb they won't let me yet. =)
I understand the want to do this. the njoy recharge is the closest ecig to a real cig I've tried. Also the air inputs are on the end of the batt and not the cart, so there is more resistance to my draw. (more like a real cig) The coils must be good because it out-vapes my Fin and eGo every time.
Now that I'm done preaching, I refilled 3 of mine last night for the first time. These were empties that came with the starter kit. W
hat I did will probably be frowned upon but I was not able to remove the cap, so I just stuck the needle tip of the efluid bottle in the mouth piece hole and SLOWLY applied efluid until it came out the connector end. I then let it set on it's side for about 5 minutes to let it soak up the fluid, then rolled it over 180 degrees and left it an additional 5 minutes. I then wiped excess from the mouthpiece and blew through it into a paper towel to clear any excess off of the coil. Next, I held it up to a light to see if I could see though it and past the coil to the light source. After that I left it sitting upright about 5 minutes to make sure any excess ran out so it wouldn't leak in to the battery. Next, fold a paper towel in to a sharp point and clean excess around and inside of connector before you attache it to the batt. Check to see if you can see through it one more time then snap it on the batt and enjoy. (at least that worked for me. no warranties on my advice! =)
Hope that helps. I love my njoys so far and hopefully this will save me some $ on the cost of their refill carts.
I was going to reply to a question about this but since i'm a newb they won't let me yet. =)
I understand the want to do this. the njoy recharge is the closest ecig to a real cig I've tried. Also the air inputs are on the end of the batt and not the cart, so there is more resistance to my draw. (more like a real cig) The coils must be good because it out-vapes my Fin and eGo every time.
Now that I'm done preaching, I refilled 3 of mine last night for the first time. These were empties that came with the starter kit. W
hat I did will probably be frowned upon but I was not able to remove the cap, so I just stuck the needle tip of the efluid bottle in the mouth piece hole and SLOWLY applied efluid until it came out the connector end. I then let it set on it's side for about 5 minutes to let it soak up the fluid, then rolled it over 180 degrees and left it an additional 5 minutes. I then wiped excess from the mouthpiece and blew through it into a paper towel to clear any excess off of the coil. Next, I held it up to a light to see if I could see though it and past the coil to the light source. After that I left it sitting upright about 5 minutes to make sure any excess ran out so it wouldn't leak in to the battery. Next, fold a paper towel in to a sharp point and clean excess around and inside of connector before you attache it to the batt. Check to see if you can see through it one more time then snap it on the batt and enjoy. (at least that worked for me. no warranties on my advice! =)
Hope that helps. I love my njoys so far and hopefully this will save me some $ on the cost of their refill carts.
Make yourself right at home! 
