no flavor at .8 on a vision eternity

[blklion77]

I'm running a .8 ohm coil w/cotton wick using .8x.1 flat kanthal . I got no flavor at max settings on a MVP what am I doing wrong

 

[Maggiemw]

I have both the MVP and the Eternity.

Personally, I do not think that either the MVP or the Vision Eternity are made for sub-ohm vaping. I doubt that the MVP would even fire a 0.8 coil. The Eternity is a lovely little dripper and deserves better treatment.

[yes, my prejudices against sub-ohming are showing]

 

[Enoch777]

MVP, while an APV, does seem to fire within certain sub-ohm ranges. You are however, not, getting the full amperage. It's also not designed for it so really, just stop there.

Build yourself some LR Micro coils, or get a mech and some good 10-20 Amp batteries like Panasonic, AW IMR, or MNKEs. Check out Avid Vapor or RTD Vapor they sell the best batteries. RTD is down right now for maint though.

 

[UncleChuck]

The Vision ET is an awful RBA dripper in my opinion. The distance between the coil and your mouth is huge, which means a huge loss of flavor and heat. As that vapor is moving up, it's also squeezed through those little holes below the tank spike, which cools it down even more. Even with higher power the vape from my ET was always cold and flavorless. Then is broke because the design is flawed. The end.

Certain devices vape certain ways, and there really isn't much you can do about it other than replacing the device if you don't like it.

 

[Maggiemw]

The Vision ET is an awful RBA dripper in my opinion. The distance between the coil and your mouth is huge, which means a huge loss of flavor and heat. As that vapor is moving up, it's also squeezed through those little holes below the tank spike, which cools it down even more. Even with higher power the vape from my ET was always cold and flavorless. Then is broke because the design is flawed. The end.

Certain devices vape certain ways, and there really isn't much you can do about it other than replacing the device if you don't like it.

I beg to differ , my experience with the Eternity being the exact opposite from yours, but life is like that, and it won't help the OP's question.

As another poster has said, get equipment that is suitable for sub-ohming, if that's what you really are heart-set on doing. Neither the MVP nor the Eternity are made for it.

 

[Thrasher]

you mean someone actually got flavor out of an eternity? tossed that thing in the junk drawer after a few hours.




as others posted that is def not a dripper for subohm coils.

 

[jandrew]

you mean someone actually got flavor out of an eternity? tossed that thing in the junk drawer after a few hours.

I get plenty of flavor from my Eternities using 30g kanthal, 1.6 to 1.8 ohm micro coils (not fully compressed) and cotton.

 

[jimbill]

I love my vision eternity and don't think it's junk at all just try some cotton and you will be fine

 

[blklion77]

Sub ohm coil was accidental . Guess I'll make a new coil and try that.