I couldn't resist when I got email notification last week. I ordered two because I think one of the guys at the local shop might want one too. I also got an extra tank for each and glad I did. I broke mine taking it off to add the orings. It was tight going over the top cap oring and didn't have the others on to keep it aligned. I love how light and small it is, should be good with summer coming. The installed spring was way to stiff, put the lighter one in right away. Airhole was too small so I made it a little bigger, might go bigger yet. The wick hole is supposed to be 2.5mm but it seems smaller to me. Maybe anodizing took up some of the space, this batch is supposed to be anodized. I'll probably end up drilling it out too. It was easy to setup and its vaping great. I'm gonna use it for a month and see if it grows on me, I really prefer dripping to tanks. It's in mind to hack this up and make a dripping hybrid out of it. Being aluminum it would be really easy to do. Cut off the top deck and shorten the brass center pin. Tap a hole or two in the bottom deck for negative screws and I'd be set! Right now I don't have the balls to do it but I'm gonna start gathering the parts needed in case I do decide to do it.
