I have two expensive Provaries in need of work, they eith flash codes or sometimes just do nothing.
What ohms is your atomizer, and what volts are you trying to fire it at?
What codes were you getting? If you answer these questions someone may be better able to try to help you figure out what is going on.
Here's the list of codes for you:
• E1 – Short Circuit / Shorted Atomizer – If this error appears, remove the atomizer and replace with a different one
or lower your voltage settings. The ProVari will automatically reset when the problem is fixed.
• E2 – Current Limit Exceeded – If this error appears, lower the voltage on the
device or use a higher resistance
atomizer. Once the problem has been fixed, the ProVari will reset itself.
• E3 – Thermal Monitor – If this error appears, let the
device cool off for several minutes before using again.
• E4 – Input Voltage to DC/DC converter error - Contact ProVape.
• E5 – Overvoltage Detected - Contact ProVape.
• E6 - Microprocessor has a problem – Contact ProVape.
• E7 – Voltage output detected when there should be none – This can be caused by a converter fault or by an open
atomizer. Only contact ProVape if you know the atomizer is good and the problem persists.
• E8 – Converter has detected a fault – Contact ProVape is this persists.
