Oh god plz halp! P3 connection stuck on atty!

[Dr. Tranny]

The top ring and P3 connector to my brand new P3 are stuck to the base of my brand new kayfun v4, and I cannot get them to separate. At all. Advice, help, tips, etc?

 

[crxess]

kayfun V4 - Smooth Bottom
Should not get stuck

Place in freezer for about 15 minutes
try again

*note - Rubber palm gloves give tremendous Grip

 

[Harlen]

Cold or heat will help but a rubber pad helps the best

 

[HMav]

Yup. Large temp change plus some sort of rubber grippy thing. I like to use those livestrong wristbands. I can wrap them around a couple of fingers and use like a mini strap wrench.

Also sticking a properly sized allen wrench in an air hole to get a little leverage works great, not sure if this applies to the V4 though.

 

[Smann245]

Rub an ice cube on the part with the male threads to shrink it away from the female threads. Works better than applying cold to both and shrinking both parts.

 

[BoomerFZ1]

Bang it against a hard, rough service. Oh, wait...

 

[Unforeseen]

Moved to Variable Voltage APV Discussion