Anyone using a DVOM? After assembly, but before I clip the wires, I thought I could touch each end of the wire to check my Ohms. I am not going to have one of those fancy smoktech things I see a lot of you have. My concern is the wires will be an inch or so longer so my Ohms will be higher than when I cut them. I guess I could do the math.
Ohm test after head rebuild
- Thread starter spegtoast
- Start date
- th_trl_thread_readers 0
- Status
After I rebuild mine I always check to see what the ohm reading is with a meter. not to sound disrespectful but the points where you will check the ohm reading at on the head is the bottom post and then pretty much any where one upper section of the head. Hope this helps
- Status
Similar threads
