Ohms discrepancy on Subtank Mini

[mjmag]

Trying the rta option on my Kanger Subtank this evening, and am overall pleased. I haven't experienced restricted airflow or dry hits as of yet. I am using the stock coil (already mounted) and the provided wicking material.
Something I've noticed, the Ohms readout on the screen varies from hit to hit, depending on the wattage setting. At 20w, it reads .9 ohms. At 25, it drops to .7 . Forgive me for lack of knowledge, but is this correct? To my understanding, the resistance of the atomizer was permanent, the volts adjusted with the watts setting.
Any feedback is greatly appreciated, thanks!

 

[Fuzzy Bruce]

What mod are you using?

 

[ImThatGuy]

Loose screw? Tighten them down including that positive pin.

 

[mjmag]

Using iStick30w, bought together with tank.

Thanks, will try that!

 

[Trailz]

Had the same thing with the mini. Today I realized the cause: Kanger didn't go with a spring loaded center pin! I have a feeling I won't be using this tank much as its very irritating.

 

[NOVA jon]

I found that you really have to make sure the RBA is snug, snug, snug down on the base. You can have the airflow open to it's largest opening and visually check and make sure you are getting a good connection!! Or at least see if it's coming up a little short!!

 

[VaPreis]

Make sure the RBA base is snug in the base section and make certain you don't have a loose screw for one of the coil leads. I haven't noticed a problem like this with my Mini. It's fairly consistent.

 

[93gc40]

The hottor the coil gets the lower it might read on a meter.. This is why measurements are correctly done at ROOM temperature. Kinda avoids comparing apples to lemons.

 

[Technonut]

Moved from Rebuildable Atomizer Systems to Clearomizers..

Since these are considered clearomizers, sub-tanks will be moved to this forum to keep all information in one place, and not scattered amongst RTA's like the Kayfun, Taifun, etc..