Ok stupid question

[EthanThorn]

When I get my 510 to ego adapter what wattage should I run a kanger mt3s and T3d at on my istick TC 40w.


Sent from my iPhone using Tapatalk

 

[aceman3330]

Hmmm, I've never tried that but I think it's up to the resistance of your coil - how many Ohm does it register, then you go from there. Hope it helps


Sent from my iPad using Tapatalk

 

[EthanThorn]

The mt3s is 1.8 and the T3d is i think a 1.5 or 1.8 I just don't want to burn out the coil first fire


Sent from my iPhone using Tapatalk

 

[Izan]

Hi namesake and welcome!

Start LOW. You may find a happy spot in the 10-15 watt range.
You are not compelled to fire at 40 watts just because you can.

Have fun.
I

 

[EthanThorn]

Well I kind of thought 40 would be to much just thought I'd ask so I don't burn out two new coils not that it would cost me a lot it's just a pain in the rear to have to go buy them again


Sent from my iPhone using Tapatalk

 

[IMFire3605]

Yeah, start out at about 7 watts and go up toward 12 to 15watts max on the mt3s, not enough airflow for any higher, that and that 34awg wire of the coil can't handle the abuse to well.

The t3d being dual coil, start at about 8 to 10 watts, then work up toward 13 to about 18watts max.

 

[EthanThorn]

Thank you

 

[mattiem]

I am running a 1.8 coil on my istick 30 right now set at 7 watts. As others have said. Start out very low and go up from there. You may find that those factory coils don't need high wattage and can even shorten their lives. The topper I am using isn't the same as you are asking about but it is comparable to them.