I have some dead Cisco 306's from over 6 months ago that I've been holding on to. I tried soaking them in 151 Vodka a while back but they still wouldn't work. Today I got an order in from IKV which included a couple of his 306's. When I put it on my ProVari I noticed it didn't screw down all the way and it wouldn't fire. The ProVari told me it wasn't detecting an atomizer connected so I pulled out one of those old, dead Cisco 306's to see if there was any difference in the threading.
When I connected it I figured I may as well try it again and sure enough it fired up and the coil was glowing orange! I almost thought I had the wrong atomizer connected but I could tell it wasn't the IKV because it didn't have IKV written on it. I was excited to try my other old 306's so I did, but none of those would fire up (figured). Then I connected the one that did fire up and it wouldn't anymore. I even connected it to an eGo battery just to make sure it was dead. It isn't doing anything now, just like before.
So now I'm wondering if there is some way to make these atties come back to life. Something caused that atty to start working again but I don't know what. Anyone got any ideas
When I connected it I figured I may as well try it again and sure enough it fired up and the coil was glowing orange! I almost thought I had the wrong atomizer connected but I could tell it wasn't the IKV because it didn't have IKV written on it. I was excited to try my other old 306's so I did, but none of those would fire up (figured). Then I connected the one that did fire up and it wouldn't anymore. I even connected it to an eGo battery just to make sure it was dead. It isn't doing anything now, just like before.
So now I'm wondering if there is some way to make these atties come back to life. Something caused that atty to start working again but I don't know what. Anyone got any ideas
