Omega questions...

[Jagellpuff]

I am considering getting the Omega, but have a few questions.

Does it work with the AW IC 18650 3100mAh battery?

What is the diameter, does it work with a 6ml DCT on it?

What is everyone's preferred method to vape it?

What's the biggest draw back to the Omega? Such as misfiring when in pocket?


Jeff "Jagellpuff" via iPhone using Tapatalk

 

[cddz]

I am considering getting the Omega, but have a few questions.

Does it work with the AW IC 18650 3100mAh battery?

What is the diameter, does it work with a 6ml DCT on it?

What is everyone's preferred method to vape it?

What's the biggest draw back to the Omega? Such as misfiring when in pocket?


Jeff "Jagellpuff" via iPhone using Tapatalk

1. Yes it will work just fine with that battery.
2.1inch diameter, you wil have to get creative on how to push the top down.
3. That would be up to you, i use my thumb and pointer finger to pull down.
4. It can fire in pocket, I normally keep it in my side pocket of my carpenter pants. A rubber band pulled into the gap would prevent that. Only time I have issues with it in the side pocket is when I am out metal detecting and I bend at the knee to recover a target.

 

[Jagellpuff]

The new version does not have the Allen screws correct?

Will the Kick work in it?


Jeff "Jagellpuff" via iPhone using Tapatalk

 

[cddz]

The new version does not have the Allen screws correct?

Will the Kick work in it?


Jeff "Jagellpuff" via iPhone using Tapatalk

This version does not use set screws, it requires a thing wall 5/16 socket to maintain it. Yes the kick will work in it along with a 18490 IMR. The sleeve will be comming for it to allow the 18650, don't have an eta quite yet

 

[Jagellpuff]

I will apologize for the questions, but just want to be sure as I am still new to mods and learning.

So with the Omega if using the Kick, could I still use an 18650 or go with a 18490?

Not saying I am going with the Kick, just thinking. I am thinking that may like a vape on a 1.5ohm carto up'd to 4.2-4.5v. Currently my Lavatube limits me at 4v.

Just want to see if options down the road are possible.


Jeff "Jagellpuff" via iPhone using Tapatalk

 

[cddz]

I will apologize for the questions, but just want to be sure as I am still new to mods and learning.

So with the Omega if using the Kick, could I still use an 18650 or go with a 18490?

Not saying I am going with the Kick, just thinking. I am thinking that may like a vape on a 1.5ohm carto up'd to 4.2-4.5v. Currently my Lavatube limits me at 4v.

Just want to see if options down the road are possible.


Jeff "Jagellpuff" via iPhone using Tapatalk

You would currently have to use the 18490 in the Omega with the kick, the extension sleeve will come later this year.

 

[Jagellpuff]

Ok, makes total sense, as the batt would get shorter, thus diff diameter, hence the sleeve! Cool!!!!




Jeff "Jagellpuff" via iPhone using Tapatalk

 

[Jagellpuff]

Thanks Chad. One more tho for you.

Voltage drop with the Omega mechanical and the Silver Bullet button.

Does either of these get affected from voltage drop?


Jeff "Jagellpuff" via iPhone using Tapatalk

 

[cddz]

Thanks Chad. One more tho for you.

Voltage drop with the Omega mechanical and the Silver Bullet button.

Does either of these get affected from voltage drop?


Jeff "Jagellpuff" via iPhone using Tapatalk

That depends on the battery really, there will always be a drop in voltage unless the source is regulated, which batteries are not.

 

[Jagellpuff]

Ok so neither the SB or the Omega is regulated. Which is typical for mods. Do you know if the Kick would act like a regulator then?


Jeff "Jagellpuff" via iPhone using Tapatalk

 

[cddz]

Ok so neither the SB or the Omega is regulated. Which is typical for mods. Do you know if the Kick would act like a regulator then?


Jeff "Jagellpuff" via iPhone using Tapatalk

The kick is a boost circuit, it will regulate

 

[Jagellpuff]

Sounds good, thanks Chad!!!


Jeff "Jagellpuff" via iPhone using Tapatalk

 

[Zurk]

Hi.any news about kick sleeve for Omega?