? on the copper pipe mod

[notsmoking]

When making the ground connection using a switch for the connection. should glue be put behind the bolt so it is the switch that make the connection. oh what the heck.... here is another question. Is there any way to make it so the switch is at the top of the mod near the atomizer? thanks alot

 

[madjack]

...say hello to a couple of other newbs and get your 5posts...wait an hour and you can post this question in the mod section and get answers from the modders...a quite inventive bunch.........
madjack

 

[notsmoking]

Thanks alot madjack... I have seen some of your posts.... great job and thanks again
notsmoking

 

[tj99959]

The norm would be to put the switch on the positve side and just allow the copper pipe to function as the ground.

 

[classwife]

You have your posts...going to move this to the Modders Forum for you now.

 

[Lance_Wallen]

generally speaking copper mods use the body as the ground (spring in end cap for neg term, body acts as path to the body of the connector at the top) then a spacer is used to hold a bolt/screw for the positive connection and isolate it from the body of the tube, wire from screw to switch, wire from switch to center pin on connector. You can put the switch anywhere you can fit it.

Ifyou're tryin to make an all mechanical version it's a lil more difficult internally but not that bad. There are a number of great guides here and on breaktru's site.

 

[notsmoking]

Thanks everyone, I have a good idea on what I need to do. thanks again