Opine Needed...

[Punk Elmo]

I am looking to return to vaping once again. Just looking for some advice.

To answer some of the questions that will be asked, the analog has been 1 to 1 1/2 packs a day since last going digital. I would not mind having MTL to start with the possibility of DTL. I would prefer a MOD that has multiple batteries. Anyways, this is the setups I were looking at for the last 2 weeks. I would go into a vape shop but most charge far too much in the SF Bay. I would hate to waste someone's time and not buy from them.

I like the look and capacity of the Wisemec line.

Reuleaux RX300
Reuleaux RX200S (Red/Black)

For a tank, I was looking at the following...

REUX (Wisemec)
Aspire Atlantis

I like the concept of top fill.

I am open to suggestions. I want something that will last me between battery charges (LG HE4 18650 2500mAh).

Any and all help would be appreciated.

 

[BrotherBob]

I am looking to return to vaping once again. Just looking for some advice.
To answer some of the questions that will be asked, the analog has been 1 to 1 1/2 packs a day since last going digital. I would not mind having MTL to start with the possibility of DTL. I would prefer a MOD that has multiple batteries. Anyways, this is the setups I were looking at for the last 2 weeks. I would go into a vape shop but most charge far too much in the SF Bay. I would hate to waste someone's time and not buy from them.
I like the look and capacity of the Wisemec line.
Reuleaux RX300
Reuleaux RX200S (Red/Black)
For a tank, I was looking at the following...
REUX (Wisemec)
Aspire Atlantis
I like the concept of top fill.
I am open to suggestions. I want something that will last me between battery charges (LG HE4 18650 2500mAh).
Any and all help would be appreciated.

Welcome and glad you joined. Mod is up to you, should be no mystery there. As to tanks, might like to read:
eLeaf iJust S Starter Kit Review | Spinfuel Vape Magazine
http://vapenw.com/catalog/product/view/id/16472/s/ijust-s-kit-by-eleaf/category/137/

 

[Darth Omerta]

Welcome aboard and glad to hear you want to start vaping again!

The 2 tanks you listed are both sub-ohm tanks. Generally speaking the wide bore tips on these tanks are best suited for DTL. Thats not to say that MTL cant be done but for me its just not as good. Ive got a few builds running for MTL hits and I swap out the wide bore for a long thin stem like tip. That usually does the trick even with the prefab tanks.

The Reuleaux RX300 is a 4 battery mod and if you are running a prefab tank you wont likely be going too high wattage wise(I like to run my Atlantis at around 35-40W and use a 50/50 PGVG mix). Even if you ran it at 100W(which I think would destroy your coils fast) you would only be drawing around 8.6A at the cutoff, so Im thinking you'll be getting a long time between charges. If you go with an RX200 then youve got 3 batteries and top out at around 11.5A at 100W at the cutoff. Still quite a lot of room for a 20A cell getting the most out of your mAh.

I will warn you that I recently purchased a 4 cell mod(iJoy Maxo) and they are pretty big. Very difficult to carry around and for me its a stay at home mod and Ive got much smaller options for out and about and at work. Sure you've got to carry a backup from time to time but I keep a charger at work for my Cool Fire IV and Ive got a sweet little 2 cell plastic case for 18650s for my mechs when Im on the go. That said....I LOVE my Maxo!!!! Vapes great and I really like the option to run in 2 cell configuration if I dont need the extra wattage.