Panzer Black Hawk top cap disassembly?

[AriahJay]

I have had this black hawk for quite some time, and recently, it has started to misfire. I initially thought it was the rda shorting, but quickly dismissed that by putting it on a friends mod and checking for shorts. I then checked to see if the battery was the culprit by putting in a fully charged, brand new battery... still had a misfire. after some research, I found out you have to clean your mods from time to time. After I cleaned the contacts and all the threads, it was working at 75% efficiency, but I am still getting a misfire from time to time. The only thing i wasnt able to clean was the top cap, and I believe that is where my problem lies. So my question is: Is there a way to disassemble the top cap so that I can get in there and give it a good cleaning? I can't find anything on the subject matter. Alternatively, could there be something else causing the misfire problem that I am unaware of? Thank you for any feedback.

 

[01Jes]

A friend had a Blackhawk panzer and it shorted which blew the battery. Not sure how it happened but the battery was hot for a long time.

 

[AriahJay]

I have established that I am not shorting, and believe there is gunk in the top cap causing a poor connection. Just trying to figure out how to clean the top cap and I would think disasembly would be best

 

[AriahJay]

I found a thread that shows how to do it, and I was able to get the firing pin out. As I suspected, it is very grimy, and it is soaking in alcohol as I type this. You simply just use a punch to tap the firing pin out through the bottom. Here is a link to the thread that I found on how to do it: http://www.e-cigarette-forum.com/forum/mechmods/590007-modifying-panzer-clone-work-better.html