Paps V4

Status
Not open for further replies.

Zutankhamun

Vaping Master
ECF Veteran
Verified Member
May 22, 2015
3,535
10,062
36
Rapture
Hello. Favourite mod ever but I've made the same mistake :(

After changing over the delrin in the switch for better tightness of the switch I have failed to seat the little pin in the button properly. It has fallen out.
IMG_0287.JPG

I've done the same thing when I first got the mod and Perseas was kind enough to send me a new button free of charge. I can't ask the guy again (even though he may, it's not right)
Can I not just use tweezers and super glue the pin in?
Has anybody done this? Does it work? I don't want to break the best mod ever.
Thanks
 

Zutankhamun

Vaping Master
ECF Veteran
Verified Member
May 22, 2015
3,535
10,062
36
Rapture
Im surprised with all the GP fans here that no one has come up with suggestions or fixes.

Did you figure something out? :)

I dont have a v4 so Im not that familiar with the switch, or that pin.

Was it just pressed in the hole?
Soldered?
If its not an electrical contact point, glue would work if you cant solder it.

My memory is so bad of late. Was supposed to reply to you anavidfan.

Right. Talk about fine engineering. I put the teenyist drop of loctite glue into that hole then put the pin back in with tweezers and held it firm.

Couldn't see any extra glue so I put it together but the switch was sticking on the fire.
Was out of sand paper so i took the edge of a knife :eek:
and gently scraped around the pin. 5 min go by and problem solved. Beautiful again.
Thanks.

BTW, this was a practice paps and I'll get another and no knives will be involved. ;)
 
Status
Not open for further replies.

Users who are viewing this thread