Phoenix V4 aka 'Mini-RDA'

[bendeng]

Ok,

Correct me if I'm wrong (no really, I most likely am).

After searching around, I was unsuccessful at finding any decent information on how to actually rebuild my Phoenix V4. The closest I got was a YouTube vid of a guy showing you how nice his modded rda works.

Being a noob at this, I need a lil more info on the initial steps.

Chime in at any time...

1) OEM Coil and wick after a couple days of dripping...
2) Airhole was super tiny so I drilled it out...
3) Tried to drill a second hole unsuccessfully...
4) Atty with old wick and coil removed!
5) Can't figure out how to take this completely apart...
6) Do I unscrew from here?
7) x_x I just wanna start building new coils and vape...

I would like to ultimately collect the info and do a write up (with some clear photos) so others can look at this for help.

Will update if I figure this out...

Sent from my SCH-I535 using Tapatalk

 

[bendeng]

Ok so a guy at the local B&M pointed out the two posts are missing screws. But it didn't come with any screws... essentially I should be able to just feed my new coil into the posts but something is blocking from inside... too tiny to see.

Back to the drawing board.

Sent from my SCH-I535 using Tapatalk

 

[bendeng]

Turns out it uses a hex key!! A very tiny one...

Sent from my SCH-I535 using Tapatalk

 

[dr g]

I think it usually comes with one ...

for 6) you dont really mess with that screw, it's not adjustable or anything.

 

[bendeng]

I think it usually comes with one ...

for 6) you dont really mess with that screw, it's not adjustable or anything.

Thanks! I didn't have one with mine which is why I've been so clueless. Haha luckily these guys are only $5 a pop. Kinda fudged it too much. I've seen youtube vids of this thing rebuilt and the results look awesome. I just ordered a couplr spare so when they get here maybe ill have this guy figured out.

Sent from my SCH-I535 using Tapatalk

 

[bendeng]

SUCCESS!

First coil I squished while torching... oops...

Second coil looks nice! Ended up putting it on a protank atty head. Works nice! Its 28g Kanthal and it read 2.8ohms on my evic.

Last coil I was finally able to connect to this rda and it works!

My evic won't read it tho but I took a few test hits off my k100.

I have an ohm reader coming in a vapemail order... can't wait to get these coils perfected!

Also, I'm wicking with organic cotton balls... getting some good flavor

Sent from my SCH-I535 using Tapatalk