Picture of Your Setup Part 2!

[K-rad]

Here is mine

 

[VapinBill]

Yup. gives everything except on how to get one of these beauties. Been eyeing these for awhile now.
I've been following his FB page to see when its going to be released but he hasnt updated his FB page since the 23 of May.

How did you manage to get 1 let alone 3? I want on that list LOL

I posted in the wanted threads on every forum I had access to. Got responses from a lot of flippers I had to weed through.

 

[The.Drifter]

I posted in the wanted threads on every forum I had access to. Got responses from a lot if flippers I had to weed through.

Thanks Bill, was afraid of that I seen some of the flippers wanted anywhere from $200-$350 more than retail for them. I guess I just have to be patient and wait it out then. Been eyeing the Ti version for myself

 

[Patricko]

JGM and JGM Genesis (by Jagus)

 

[Patricko]

Nzonic V and GkmF22 mini

 

[moralizer]

Nzonic V and GkmF22 mini

That is a seriously good looking setup. Way out of my budget though.

 

[AnicLyke]

Zna with an aspire Nautilus with a bvc coil. 13 watts most of the day but up to 16 if I'm in need of a hard hit.

 

[vapero]

Here is mine

beautiful patina! how did you manage to do it? is it natural??

 

[The.Drifter]

Heron on Carvela in 18350 mode

 

[MaxSjobeck]

My Aspire Nautilus with the mesh sleeve tank, on an iTaste SVD.
Nothing fancy. Just my startup gear as a new vaper.

 

[0dBu]

just above the "u" in the logo....lol....kinda blends in right?
ill post other pics tomorrow......look a bit closer at the logo and use a SMALL drill bit

Okay, I see it now. Yeah, that's doesn't look too bad. Did it impact the flavor at all in a negative way, that's what I love about the Vulcan?

 

[t2ak]

Made a mid section for my TOBH Atty to match my Manhattan mod.

7075 aluminum
CNC milled

Sent using these stoopid hooves..

 

[bigmaaark]

Made a mid section for my TOBH Atty to match my Manhattan mod.

7075 aluminum
CNC milled

Sent using these stoopid hooves..

that looks good!

 

[t2ak]

that looks good!

Thanks, I wish we had some stainless laying around that was large enough. Turned out alright for being a 1st run and on a older CNC mill, not a lathe.

 

[vaptamist]

Super-T ELA V2 with Strata

 

[ZeroOne]

The set up I'm using right now is a IPV V2 with a Zenith V2 clone

 

[searchwiser]

Chilling on the net

 

[The.Drifter]

Rearranged parts on my Cartels and Stillares for something different

 

[Bunnykiller]

okay... how about this....



loaded with my DIY nuclear reaction juice....

 

[Polo65]

You're not going to lose that one! Pretty cool!

Nice . Very colourful lol