4 days in with my EHPRO KFL+ and I've had nothing but problems. Alot of these are probably because I'm new to rebuildables but aside from the tank size, my Trident clone is blowing it away by a huge margin on all categories.
1. Solved the loose driptip situation by switching out the o-ring on it.
2. I'm getting LOADS of leaking from the airhole on the side. I've followed advice on putting the piece to an angle and blowing into the hole but this has only been a temporary solution as it tends to have another round of leaks after. All o-rings are good and my air adjustment screw is out. Not sure what's causing this.
3. The vapor production and wicking. I'm pretty sure it's not doing this right. I got my build set up by a very reputable vape shop down here so I could learn how to construct a build on my own and while the cotton/coils physically look fine, there's barely any vapor coming out of it. Like each hit I'm taking is cigarette-sized vapor or less. Many hits generate no vapor. I've taken the piece apart and fired it off to see if the piece is wicking correctly and there's still barely any vapor coming out.
On a positive note my friend pre-ordered the Stingray clone for me and I'm quite excited.
