Todays setup... Going old school and rockin' the 510. My SVD now seems waaay to big.
Picture of Your Setup Part 2!
- Thread starter QuietProSF
- Start date
- th_trl_thread_readers 0
- Status
Todays setup... Going old school and rockin' the 510. My SVD now seems waaay to big.
In an old school cigarette case... Looks silver? Veery classy buddy 
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
Todays setup... Going old school and rockin' the 510. My SVD now seems waaay to big.
I know what you mean. I'm about to breakdown and get an eroll.
Sent from my Nexus 5 using Tapatalk
In an old school cigarette case... Looks silver? Veery classy buddy
Sent from my iPhone using Tapatalk
Yeah, came with a very cheap case, I took out the insert and trimmed it to fit into an old silver tobacco tin.
For the record
Sent from my iPhone using Tapatalk
You, Sir, are my hero.
I just finish installing the dna (you guys are the first)it have 3 fire botton and it goes up and donw using the plus and minus on the control plus the cross seccion
I have been working on installing the guts of an MVP into a gamecube controller. It's going slowly since I work so much, but hopefully I'll have it up and running soon.
Sent from my Third Eye using Tapatalk
The hard part is find the circuit from the board of the control insulated from the control board and attached to the mvp board
thanks for the compliments everyone and sorry i neglected to post any info.
first one on left was the my first mod that i made. 18650 battery holder, aga-t+ gen atty, with variable voltage via boost converter. casing was an aluminum project box that i polished up, drilled some holes in, and engraved in my free time.
the one in the middle was intended to originally serve as my spare mod, but i wanted to make something as small as possible that still had enough juice/battery to get me through the day. its basically an 18650 holder with a bracket that i made out of aluminum sheet to hold a genesis atty. uses a tact switch (the little black nub on the left below the atty in the pic) and mosfet for firing. holes drilled to lighten things up and because it looked too plain without it.
the last one is my new bottom feeder that i made recently. 18650 inside, 10ml bottle, modified igo-w for bottom feed, housed in a modified aluminum project box. the square in the upper right corner is the switch and this one also uses mosfet for firing. running dual coils right now @ 0.6ohm without issues.
there are more pics of everything in some of my other posts:
http://www.e-cigarette-forum.com/forum/modding-forum/526225-my-new-bottom-feeder.html
http://www.e-cigarette-forum.com/forum/apv-discussion/517023-my-homemade-mods.html
Last edited:
So two of these I posted saturday but I ended up picking up a couple more yesterday so here is my collection from this weekend.The mecs are clones but suprisingly very well built. I'm going to have to cool it now as I blew most of my vaping budget this weekend haha 
My modest collection. Sorry just to much to name everything. Had to stop a couple of months ago due to mounting medical bills, but I think I'm good for now.
Sent from my Note II using Tapatalk.
Sent from my Note II using Tapatalk.
- Status
Similar threads
