Picture of Your Setup Part 2!

Status
Not open for further replies.

Big Juicy

Ultra Member
ECF Veteran
Verified Member
Mar 22, 2013
2,919
7,075
Placentia, CA
Beautiful pipe!! (Interesting C.S. Lewis quote too - trying to decide which I am, haha!)

Well...is there a pipe in your mouth?

I vape nothing but epipes anymore, except for one cigar mod

MONTE22.jpg

I have pipes from a few vendors, but all are welcome and represented at the ePipeMods forum, found here:

Home | ePipeMods Forum- The Forum Home of ePipeMods and the Greater ePipe Community

Stop in and hang a while, one and all...tell then UNCLE BJ sent you
 
Last edited:

pastubbs

Super Member
ECF Veteran
Jun 24, 2013
308
564
Chattanooga, TN USA
pastubbs.com
So I've noticed with my kfl when I vape outside in cold temps the taste gets burnt. Is there anyway to fix that?

Sent from my SM-N900P using Tapatalk
When the juice gets cold it thickens up making it harder to wick which gives you dry burns. I had a lot of this lately leaving mods in the car and with the sub zero weather we've had lately. I've burned quite a bit of cotton.
 

Plumes.91

Vaping Master
ECF Veteran
Verified Member
Jan 30, 2012
5,078
6,388
United States
e2yhypys.jpg

Mmm copper hcigar nemesis clone <3

Daaaammmmmnnn, you suck! I want one!

& jeeee collection of SS mods with the SS attys... MMMM, buddah! Makes me want to chrome my room's walls. :p Love that. & oh gawd did that gorgeous wooden pipe make my mouth water. I have a pipe but it aint that nice, I'll post a picture of mine tomorrow lol. :D

AND OH SHEEEESH the DNA mods!!!!!
 
Last edited:

Red Winter

Full Member
Verified Member
Jan 19, 2014
50
121
Brighton, UK
how can you tell its a knock off?

I ordered it from Slowtech. :p

On a more serious note:
- engraving feels "gritty"
-- real one is smooth
- 18350 tube and 18650 extension have a slight bevel where they meet
-- real one has really sharp edges and it sort of blends in
- vent holes in 18350 tube are not centered or located at right angles from eachother
-- real one has (think clock) vent holes located at 12-3-6-9, holes at locations 12 and 6 are centered under figure's feet and serial
 
I ordered it from Slowtech. :p

On a more serious note:
- engraving feels "gritty"
-- real one is smooth
- 18350 tube and 18650 extension have a slight bevel where they meet
-- real one has really sharp edges and it sort of blends in
- vent holes in 18350 tube are not centered or located at right angles from eachother
-- real one has (think clock) vent holes located at 12-3-6-9, holes at locations 12 and 6 are centered under figure's feet and serial

thanks for the heads up just going over mine trying to see if its a clone or not lol
 

SkvLTD

Super Member
ECF Veteran
Verified Member
Nov 10, 2013
549
235
MD
skvoraltdphoto.com
Still playing w/ my 1.3ohm wrap Fogger.

Found a nice and easy way to adjust the air pipe in case it gets partially blocked by the positive post's silicone buffer ring inside the AFC chamber- "over" screwing the bottom contact screw simply rotates the inner air hole assembly without affecting anything else and with some steady dry tugging it's fairly easy to tell when it opens up fully.
 
Status
Not open for further replies.

Users who are viewing this thread