Picture of Your Setup Part 2!

Status
Not open for further replies.

qorax

ECF Guru
ECF Veteran
Verified Member
Mar 6, 2013
12,652
41,477
Brampton, Canada
www.facebook.com
2co26p0.jpg
 

TruSound

Ultra Member
ECF Veteran
Verified Member
Aug 20, 2011
1,427
2,604
Granada Hills, Ca
I used that same set up for a year, I did not have the nano tank there was no such thing at the time. I still have em both you cant beat em.

The only thing that slightly bothered me about the Nemesis was the mile wide button to locking ring gap, this gap was easily narrowed by shaving down the top contact, if you do this make sure you do it in stages a little at a time and check to make sure it fires…just a MM makes a big difference.
 
Last edited:

thetrucker

Ultra Member
ECF Veteran
Jan 10, 2014
2,045
3,490
74
Syracuse,NY
This is my third homemade E-pipe

First pic is the parts used--second pic is the completed pipe

third pic is bowl before a puff and fourth pic is bowl while puffing

painted inside of bowl white to reflect lite from end of battery a little more

Just fooling around with an easy idea for an E-pipe

Will look for a red lens to fit into bowl today at hardware store

(1) PartsUsed.jpg (2) CompletedPipe.jpg

(3) BowlBeforeApuff.jpg (4) BowlDuringApuff.jpg
 

erieboyz

Super Member
ECF Veteran
Verified Member
Oct 19, 2014
461
1,280
My new tank.......Freakin love it! Closest I've come to a tank hitting like a dripper. Had to drop to 6mg Nic in it (usually vape around 18mg in my tanks). Even at only 20 watts and using the occ coil that came with it instead of the RDA head this thing blows cloud [emoji14]
cad59a58b19f39d3bf7494d70e308421.jpg

Sent with one hand, the other is busy vaping.
I'm actually going to be purchasing one with a ipv mini next week. Question for you. At 20 watts, does it produce a warm vape?
 

NewCloudzCity

Senior Member
ECF Veteran
Verified Member
Jun 24, 2014
251
199
On a Cloud Brooklyn, NY
  • Deleted by Unforeseen
  • Reason: Unregistered Supplier

USMCotaku

ECF Guru
ECF Veteran
Apr 25, 2014
11,877
45,735
California
I'm actually going to be purchasing one with a ipv mini next week. Question for you. At 20 watts, does it produce a warm vape?


Have only used the 1.2 ohm occ so far, and with that at 20 watts the vape is abundant but cool. I imagine that the .5 ohm occ coil it also comes with will give a warmer vape
 

USMCotaku

ECF Guru
ECF Veteran
Apr 25, 2014
11,877
45,735
California
Ok thanks for the heads up.


I just tried the rba head on it for giggles with the pre built coils it came with, which was a dual coil build that turned out to be .5 ohm, and the vape was much warmer. The air flow was a bit more restricted, but was still able to lung hit off it. I think a good single coil build like a Clapton or twisted wire will have better air flow through the rba head..... Less cotton. It seemed to wick plenty fast enough, but it does the tank capacity from 6ml to 4.6ml...... But it sure out performs my kayfun, and I already built that with a Clapton coil. Can't wait to see what this sub tank will do with a coil like that in it!
 

erieboyz

Super Member
ECF Veteran
Verified Member
Oct 19, 2014
461
1,280
I just tried the rba head on it for giggles with the pre built coils it came with, which was a dual coil build that turned out to be .5 ohm, and the vape was much warmer. The air flow was a bit more restricted, but was still able to lung hit off it. I think a good single coil build like a Clapton or twisted wire will have better air flow through the rba head..... Less cotton. It seemed to wick plenty fast enough, but it does the tank capacity from 6ml to 4.6ml...... But it sure out performs my kayfun, and I already built that with a Clapton coil. Can't wait to see what this sub tank will do with a coil like that in it!
That's awesome. Can't wait to compare the rba section with my lemo.
 
Status
Not open for further replies.

Users who are viewing this thread