Plastic melters and filling.

[gr1llmeacheese]

Ok, so I just made a pretty bonehead mistake. I just stopped by my local B&M with the intention of getting nothing more than a blunt tip syringe to use for filling a Davide with radiator pluid. Walked out with some 32g Kanthal some wick a shiny new Phoenix clone rda and no freaking syringe. I need to start making lists when I go.

Anyway, I have an empty bottle with a needle tip cap and I was going to use that but I wasn't sure if the bottle was going to melt in the amount of time it took me to fill the tank.

Any insights?

 

[Aubie80]

If you do it this way just make sure to put the remaining pluid back into the glass bottle it came from and rinse the other bottle and needle out really well.

 

[gr1llmeacheese]

Thanks, unfortunately I terrified a pharmacist tonight asking for blunt tip needles.

 

[Aubie80]

Thats odd, i would think they would be used to being asked for all kinds of needles before.

 

[DirewolfUSMC]

Thanks, unfortunately I terrified a pharmacist tonight asking for blunt tip needles.

Not surprising, depending on what part of Aurora said pharmacy is located.

I'm curious, what local B&M did you visit? I wasn't aware of any in the Fox Valley area.

 

[Shadav]

giggles I'm sure they debated calling the cops on suspicious activity

 

[gr1llmeacheese]

Dire wolf, their name is High Tech Vapors and they are on commons Dr. Close to the foundry bar/mall. Really good people.

 

[gr1llmeacheese]

...and it was the new-ish walgreens on galena, so west side.

 

[DirewolfUSMC]

Dire wolf, their name is High Tech Vapors and they are on commons Dr. Close to the foundry bar/mall. Really good people.

Sweet, I didn't know there was a vape shop there. I have GoodeJuice right over by me.