Pro Tank Base issues

[ryguy732]

Hello all,

I was wondering if anyone could help me out. I have had a pro tank for a while and I haven't used it in a few weeks. I put a new head in and I kept getting a low load reading however when I screw the same head into an evod I get a 2.2 ohm reading. I think I have narrowed down the issue to something with the metal base and screwing in. It screws in smooth and tight but the center pin doesn't seem to be making a connection through the base. Has anyone encountered this or any thoughts on how to resolve this issue? Thanks in advance!




Sent from my iPhone using Tapatalk - now Free

 

[Austine_Devine]

I have noticed that the heads barely stick out of the bottom of the protank base. I have had to screw the atomizer harder than I would have liked to get a connection. Since the atomizer sits so close to flush, you have to make sure that a little bit can make contact with the center post of the battery. The reason it works with the EVOD ring is that the positive part sticks thru the ring to make the same connection. Happy vaping and hope this helped.