I recently purchased my first authentic kayfun Lite Plus. When I mount it on either one of my Provari's with a beauty ring there is still a gap and the ring just spins and rattles. I have two rings, one is the Lokilab and the other is the one from Provari. Both are the same with the KFL but are perfectly fine with the 3 kayfun 3.1 clones I have. Anyone else have this problem? Is there another ring that works with the Lite?
Problem with provari ring with kfl +.....
- Thread starter wagon52
- Start date
- th_trl_thread_readers 0
- Status
I never found a perfect fitting ring for my KFLs. It's in large part with the ProVari not have an adjustable or floating 510 pin.
That's the way it is with the kayfun and the Provari....no rings work...tried them all. I'm ocd about it and found this thread about how to shorten the 510 pin insulator. I can tell you that I followed these instructions and it worked and it was easy. Like it says go slow and keep checking because you can't go backwords if you sand too much. It's not as scary as it seems once you get started. I'll post a link...but if it doesn't work you can google Provari Kayfun 510 insultor...it's a thread at uk vapers with pictures.
Obviously if it bothers you enough to try it.
How to shorten the Kayfun Lite centre pin
Obviously if it bothers you enough to try it.
How to shorten the Kayfun Lite centre pin
Also should mention that after I did this adjustment...the Kayfun still worked fine with all my other devices.
I had to do this to get my clone Kayfun to sit flush. But to get the insulator off, without damaging it, what a pain.
- Status
Similar threads
