PROBLEM: YEP RDA negative post milled badly

[Pshay1292]

I got an authentic yep rda off rbavaporstore.com. The screws that go into the posts are so long that, with 24 gauge in the post, the screw won't start to screw into place. I got 28ga to fit and I can screw them down but 24 gauge doesn't work. Is there anything I can do to change this?

I was thinking I could sand the screws down or maybe drill the post holes bigger so that the kanthol has more room to be tightened down with the screws

Thanks for any help

 

[Pshay1292]

The negative post on my yep rda which I got from: rdavapor.com is milled terribly. I can barely get the screw to back out of the post hole and I also can't get the screw to hold thread enough to tighten the connection. Should I contact rdavapor and ask for a refund? A return? Will they even do anything about it or just say sorry man you got a dud.

 

[NancyR]

I can't tell you what they will say, but I would contact them.

 

[Equilibrium]

Ya never know until you contact them.

 

[Robino1]

Merged two threads as they were about the same issue. They were worded differently enough that just deleting the duplicate didn't make a whole lot of sense.

Also a bump for possible help for you.

 

[BigCatDaddy]

The negative post on my yep RDA which I got from: rdavapor.com is milled terribly. I can barely get the screw to back out of the post hole and I also can't get the screw to hold thread enough to tighten the connection. Should I contact rdavapor and ask for a refund? A return? Will they even do anything about it or just say sorry man you got a dud.

Most places will allow returns if it was DOA. Drop 'em a line and see what they say.