Problems...wondering if anyone has a thought on a solution

[warriorwolf]

Hello Folks,

I have two APVs (Vamo V1, Smoktec epipe) I am finding that the epipe is not producing alot of vapor or taste, I have been using Kanger 65mm 1.8ohm cartos and the first gen AGR 45mm tank. batteries are Efest. Punched hole is about the side of a paperclip wire

Second is the VAMO. It has been shutting off, I would take a vape, the screen would blink twice then shut off. I am using it in 18650 mode. Current using a vapeonly BCC 2.5ohms, VAMO set on wattage at 8.5

juice is consistently a home mixed 70/30, nic level is less then between 8-10 mostly a Berry menthol mix

On a side note I have been finding that my front gums are getting numb I was wondering why that would be

Thank you for your time, happy holidays

 

[crxess]

Vamo - check that center pin is not getting crushed - they can short out. Read up in the Vamo sub forum. Battery may also be on its last leg and having trouble pushing power required.
epipe should be working with those specs. Mat be the choice of Carto, but it sounds like it may need another hole with the 70/30. I run Boges with 2 holes (1mm) each and vape 50/50. Also check for decent air flow at the tank base. Low air flow can/will choke off vapor production and make vape a bit tighter.

Numbness? Possibly from always vaping Menthol. Menthol is used to cool and sooth(numb)