• This forum has been archived

    If you'd like to post a thread, post it here instead!

    View Forum

protank qns

Status
Not open for further replies.

winx19

Senior Member
ECF Veteran
Verified Member
Jul 20, 2012
135
31
w.est
hi fellow vapers,

recently got my hands on the protank and some menthol base juice, recently after each drag, it seems tat the menthol in the juice is gone. But blowing into the protank, the menthol came back again. I change the heads just to see if there is any improvement, but after 10 drag, i go the same prob.

Anyone who has used protank exp this as well? any solution to that?

a side qn, what element in a juice that would cause it to break a plastic tank (stardust)? If it can break a tank, is it still safe to vape?

thank you in advance for all your advice.

vape safe.
 

winx19

Senior Member
ECF Veteran
Verified Member
Jul 20, 2012
135
31
w.est
Increase the voltage or reduce the resistance of your coil. The power in your setup is not enough to bring out the flavor in your juice

Sent from the sky

noted on your advice, the resistance on the head is 2.2 ohms, while i using vamo at 4.0 volt. will increase them and try it out...

cheers
 

Silrom

Full Member
Verified Member
Jun 5, 2013
58
5
Borneo
hi i have a protank related question and i was wondering i can ask here? are there any fake protanks ard? coz i found one which is cheaper by over 10bucks and i dont know if i should take the jump on this?

Hard to say i think. Some bought protanks in bulk and it will cost a lot cheaper. If seller is outside of lil island then i think it's possible.
 

winx19

Senior Member
ECF Veteran
Verified Member
Jul 20, 2012
135
31
w.est
Hard to say i think. Some bought protanks in bulk and it will cost a lot cheaper. If seller is outside of lil island then i think it's possible.

i agree... [*removed] was quoted abt the same rate as per somewhere else. But didnt get it cause the packaging was a bit funny looking...
 
Last edited by a moderator:
Status
Not open for further replies.

Users who are viewing this thread