Provari Accessories (Opinions?)

[dmenace79]

I have recently purchased a Provari and have the[h=1]ProVari Power 2500 Rechargeable batteries, but the site recommends the AW Rechargeable batteries.[/h]
Questions:

1. Why does the site recommend one over the other?

2. Which battery will really preform the best?

3. Does the AW require the ring?

4. Which cartomizer and/or tank combo is the best?

Thanks for the help.

 

[kabonk]

I use the 2500 mAh batteries and get good life out of them a day and 1/2 to 2 days and I don't use the ring, I think they recommened the IMR before they started selling the 2500mah batteries, I like the boge 3ohm cartos, I have a aluminum liquidator, a j-tank and many home made syringe tanks they all seem to do the same job its really a matter of how much do you want to pay.

 

[Tekkamaki]

You need to check out this site: 18650 battery test 2011.

 

[kabonk]

its regulated voltage it doesn't matter

 

[dmenace79]

Kbonk,

Is there a place to go for instructions on a homemade tank? Also, do you punch your own holes in the cartimizers or do you purchase them pre punched? Where do you purchase your Boge cartos?

 

[kabonk]

there's a big thread on the general page its has a video on the first post so you don't have to weed through the 150 pages if you don't want to I use a dremel but some people use a screw some use a http://www.e-cigarette-forum.com/fo...sion/231694-best-thing-ever-punch-cartos.html
http://www.e-cigarette-forum.com/fo...756-homemade-syringe-tank-mod-looks-easy.html

 

[Jeremy-WI]

there's a big thread on the general page its has a video on the first post so you don't have to weed through the 150 pages if you don't want to I use a dremel but some people use a screw some use a http://www.e-cigarette-forum.com/fo...sion/231694-best-thing-ever-punch-cartos.html
http://www.e-cigarette-forum.com/fo...756-homemade-syringe-tank-mod-looks-easy.html

I use a dremel with a cut off blade in it to cut a slot instead of punching/drilling a hole in my boge 2.0 ohm cartos. It was the easiest at the time, hammer and nail failed, new drill bits would barely scratch the metal of the carto and I didn't want to use my drill press and get the carto crushed or out of shape. I even tried wire strippers and all they would do is smash the carto instead of punching it. Just find a way to do it that you like