Question from Newbie about DCT

[DaveyC]

Today, I got in my DCT from TW, and my battery to match (501) and did just as the guy said. Let it dry, it leaked out the bottom, but then after my first hit, which tasted fine, I noticed it kept hitting, even after I stopped sucking, and then the battery LED blinks.

Is this because I burnt my cartomizer?

 

[VpnDrgn]

Sounds to me like you have an automatic battery. If you let juice get into those, the auto switch will get stuck
and it will keep firing until the timed cutoff will kick in ( blinking LED ).

 

[DaveyC]

That is exactly what happens, is this bad, and if so, is their anything I could do to fix this?

 

[madmartyr72]

If it is the kind of auto batteries that have the hole that goes down the center of the post, what you can try is to tear off a little piece of TP or paper towel and roll it between your fingers until it is skinny enough to put down the hole (make it long enough so it doesn't get lost in the hole...would be bad). Twist the paper a few times inside the hole and then see if it is covered with juice when you pull it out and if so, twist another piece of paper and rinse and repeat until you no longer see any juice. If your auto batteries are sealed and juice still got in somehow, your battery may be shot.

 

[DaveyC]

Thanks for the advise, I will try it, and get back to you! It doesn't seem shot, because it works and I get lots of vapor, it's just it fires until it blinks, like the gentleman said before you, and I wanted to know if that was bad, or harmful.