Question on a Lambo

[Raynman]

How fast will this thing go? Only kidding. I got a Lambo 2 weeks ago and for some unknown reason it wants to show the ohms when I press the fire button. I thought it had just lost the setting to show ohms and it just came on every 5th press but it might happen and happen again 2 button presses later. Then it might not happen until 10 presses later. Is this a known issue that can be taken care of or did I buy a lemon rather than a Lambo?

 

[SupplyDaddy]

Lambo?? Vamo?

 

[Raynman]

Just a guess but I'd say they are the same. If you want to look at it its on the hoosier vapes site listed under the HV3 kit 4.0. It doesn't look the same but I believe it is a knock off. doesn't have the VW option either,

 

[SupplyDaddy]

No, not the same.. more of a Lavatube, so only help I can give is their own instructions.. Sorry
HV3 TUBE FEATURES

Hold red power button for 5 seconds to turn on/shut off unit
Press red power button 7 times to check remaining battery volts
Press fire button 5 times to check ohms
+/- buttons to increase/decrease voltage from 3.0 to 6.0
Vent hole in bottom cap for safety, and spring for battery tension.
Red LED screen
Sealed 510 connection
Chrome body with manual button

HV3 is designed to only be used with the panasonic IMR batteries sold here.DO NOT stack batteries in this unit! Use of any other batteries will void warranty, and will be potentially dangerous. Hoosier Vapes will not be held responsible for any occurrences caused by using aftermarket batteries or chargers with this unit. Use only as sold, and intended.
For Specs and more information on batteries and charger, please visit those pages at...
Panasonic IMR (high drain)
Soshine dual port 18650 charger

 

[Raynman]

Thanks for the input. It also stops in the middle of a vape sometimes as soon as a half second into it and goes to the ohm screen.

 

[Raynman]

Bump it to the top/

 

[SupplyDaddy]

It would seem that it was a clearance item.. might be a reason...