This is my first time to use the kanger rda because I've been buying the OCC for the last month. Every build I do it says check automizer even with the factory build the comes with it says the same. Any Help?
The build deck need to be really snug in the base. Also check to make sure the center pin on the deck is making contact with the base. Might have a little play in it and you can gently manipulate it to make contact!!
Good luck, I love the rba deck more the the remade coils myself!!
The build deck need to be really snug in the base. Also check to make sure the center pin on the deck is making contact with the base. Might have a little play in it and you can gently manipulate it to make contact!!
Good luck, I love the rba deck more the the remade coils myself!!
as mentioned above, make sure to snug down the rba in the base.
play around with wicking, but if you are using the original rba (no round holes in the sides) then you might want to look up pancake wicking if you are doing high VG juices. otherwise any fairly normal wicking will work well.
I have found that the post with the insulator is really loose. It makes it so the ohm reading is never accurate causing the ohms to jump any time I touch the rba base and sometimes not seeing the coil at all.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.