Rainbow Heaven Killer 705 Clone

[thomasjames0]

Hello fellow vapors. I have had my eye on the Diver and Killer for awhile now. I was not aware that rainbow heaven was cloning the killer until I saw it at siIicawicks.com. If it is anything like their Term C and Ithaka offerings i think we're in good shape. I ordered 2 and will report back ASAP. If anyone else has one please report back on your findings: build quality, performance, ease of use and the like.


Killer 705 SS Clone (By Rainbow Heaven) | Silica Wicks

 

[jmarkus]

sweet, ordered 1. thanks mate.

 

[thomasjames0]

I wish I could give a review but I broke the ceramic cup straight away. So as is, you get the killer clone with a ceramic cup and no prebuilt wick. I do not own the original but construction looks and feels pretty solid. Threading at the bell is smooth, however, threading at the adaptor felt a bit off to me.

 

[Jaseruckus]

Even with the positive wire in the ceramic cup, it was still loose when inserted onto the post. When you do set it up, be sure to remove that rubber insulator from the 510 adapter. It blocks the air path. Also, I don't know about yours but mine didn't have an o-ring where you install the ceramic cup. On my next rebuild, gonna try to use an o-ring from an unused drip tip. Wish I had a tank with a fill hole, I'm losing about 1-2 ml of juice due to removing the caps for refills.

Don't have a real killer but I'm getting the same performance I get from my Divers. Plus, like mentioned above, it's built pretty solid.

 

[thomasjames0]

Well you saved me with the recommendation of removing the insulator from the 510 connection. I found an extra ceramic laying around and I'm vaping away now. After I removed the insulator however, the pin connection has nothing to grab to so it rattles around. Did you remove both insulators? I took both off and screwed the pin back in resulting in a pin that just rattles around resulting in me losing connection if i open the juice control too far.

 

[thomasjames0]

Also, I don't have an o ring either. Where is this supposed to be installed?

 

[Jaseruckus]

I only removed 1, the one blocking the 2 air holes on the 510 thread. You probably need to put back the other one, nothing is loose on my after removing just that 1 insulator in the bottom. My problem was maybe the ceramic cup that mine came with was too opened where the cup sits on the pin. I would recheck it but right now mine is vaping great and don't want to break anything down until my coil needs to be replaced. If you want to pick up more, you should check out Buckybargainvaping.com forums. Once you register, the co-op section pops up. He has these selling for $5.78 each and ceramic cups for 50 cents. You can even get some premade nr-r-nr coils. I think they come with 50 premade coils for $3 ( 1.2 - 1.8 ohms )

My diver and ebaron pro dripper both have o-rings at the bottom of the threads of where the top sections screw on. It's to seal off juice from entering.