I have a cobra clone and whenever I try to make it ss wick it dont wick I'm using 400 mesh I have tryed putting wick in it I have tryed 2 wicks in one I make amazing coils In my dripper and I know the coil is good on the cobra please help been trying to get this to work for 2 months and no luck I'm using a k100 and I have tryed 28g and 32g tryed lose wicks and tight wicks tryed with a hole In the middle and without I keep wanting to toss it but I payed 40ish for it
- Status
Have you tried keeping the fill hole open? Apparently that helps with wicking issues on Genesis-style atomizers sometimes.
I use an RSST which is of course quite like what you are using. I have absolutely no issues in fact the thing vapes too well and I rarely use it these days.
Roll the wick super super tight, only oxidize the upper part of the wick (leave the part of the wick that goes into the tank alone) cut a little snip out of the bottom of the wick at an angle before putting it into the tank, wrap your coil tight but not so tight it squeezes the wick, make sure air hole is next to wick and facing you when you vape.
Roll the wick super super tight, only oxidize the upper part of the wick (leave the part of the wick that goes into the tank alone) cut a little snip out of the bottom of the wick at an angle before putting it into the tank, wrap your coil tight but not so tight it squeezes the wick, make sure air hole is next to wick and facing you when you vape.
Make sure your wick absorbs juice before you install it. Make sure it's hollow, put it on a paper clip and drip juice on it. It should absorb immediately. If it doesn't burn it off with a flame and repeat till it saturates easily.
On my AGA-T2 the fill hole is on the opposite side of the wick hole. If I tilt it to ensure the wick is saturated I don't get any leaking.
Thanks everyone the fill hole is open And I have tryed everything still no luck it has like a gross tast and a burn taste but thanks any more ideas
Is the coil contacting the SS mesh everywhere? If the coil is too loose and there is a gap between the coil and the mesh you can get a metallic/burnt flavor from it.
I had a similar issue and followed the method that has you wrapping the coil around a proper sized drill bit then sliding the wick through it and it worked first time! Cant remember the name of the guy that did it but it is on youtube and very easy.
Give it a try.
Give it a try.
I will try that when my kids go to bed I mean it looks like it is I will try the drill bit thing and see if it help thanks everyone one more question do u have to make weaker juice Wendy use drippers bc I have noticed if I use a juice that has little flavor it has to much taste with a dripper
- Status
Similar threads
