===rda assistance needed===

[deadyouth]

Hi! I'm new to this site and vaping. What would be a good rda for a starter? My friend gave me his IGO w6 rda w/ a K100 mod, which I really enjoy. The w6 is a bit advance for me however. Anything you guys recommend that is cheap, preferably only has 3 post and gets good flavor/clouds?

 

[Susan~S]

Hello and welcome to the forum. Glad to have you here!

First, a few questions for you.

1. Do you have an ohm reader or a DMM?
2. What battery are you using (brand/mAh/amp rating)?
3. Have you read up on battery safety, ohms law, amp draw?

 

[AzPlumber]

The IGO-W is about as basic as it gets for a 3 post RDA. Make sure you also get yourself a volt and ohm meter. Never push the fire button unless you know for certain the resistance of your build and that you don't have a short.

 

[Pyre13]

A decent 3 post to start off with would probably be either a stillaire clone or a patriot clone. I started off with a magma clone by infinite and it's fantastic. It's only two post but it has deep vapor wells and the flavor is phenomenal.

 

[bpearson]

My first one is a Mephisto. So far as I can tell it's about all you could want either way. It's a three post with a deep well and the post holes are above the well so putting coils in is cake. and the post holes are gigantic so you could put (just eyeballing) wire about as thick as a pen ink cartridge in it. Might be one to look into

 

[Cloudz4Days]

I can't give you any answers until you reply to Susan~S' questions