I just got my mutation xs in the mail yesterday and have been having a few issues/concerns some of which I had fixed but I am still confused on others.
1. because the rda has 3 sized air holes ( one big circle then one medium and one small circle ) for bottom air flow does that mean my coil must sit over the biggest air hole at all times?
2. how do I stop liquid from leaking from my air holes? seems like I constantly am wiping my RDA when going to drip more.
3. I have a decent experience with building the coils themselves but I'm having a LOT of issue when it comes to wicking. does anyone know of a good tutorial video that can help with this. just did my 3rd build today, first two were single coils and the first I put too much cotton so it had wicking issues and the 2nd too little cotton. now I'm running a dual coil at .44 ohms but I feel I may have put in too much cotton but I am not sure. I also am having issues where to stuff the cotton after its inside of the coil. some people say under the coil itself like a bow tie others say not to do that.
one side is typicall okay as it's the short end and so I just stuff it right into the edge of the juice well but the other long side is where I typically screw up. should I cut past my rda deck, at the rda deck, etc..
4. my RDA isn't putting out a lot of vapor as some other ones I see online I mean it puts a decent amount for an RDA but not something i'd recommend as "Clouds" how do I adjust it so it does this? I'm using mainly VG juice, air flows are all open. I'm running again a 0.44 ohm dual coil at 20-21 watts
1. because the rda has 3 sized air holes ( one big circle then one medium and one small circle ) for bottom air flow does that mean my coil must sit over the biggest air hole at all times?
2. how do I stop liquid from leaking from my air holes? seems like I constantly am wiping my RDA when going to drip more.
3. I have a decent experience with building the coils themselves but I'm having a LOT of issue when it comes to wicking. does anyone know of a good tutorial video that can help with this. just did my 3rd build today, first two were single coils and the first I put too much cotton so it had wicking issues and the 2nd too little cotton. now I'm running a dual coil at .44 ohms but I feel I may have put in too much cotton but I am not sure. I also am having issues where to stuff the cotton after its inside of the coil. some people say under the coil itself like a bow tie others say not to do that.
one side is typicall okay as it's the short end and so I just stuff it right into the edge of the juice well but the other long side is where I typically screw up. should I cut past my rda deck, at the rda deck, etc..
4. my RDA isn't putting out a lot of vapor as some other ones I see online I mean it puts a decent amount for an RDA but not something i'd recommend as "Clouds" how do I adjust it so it does this? I'm using mainly VG juice, air flows are all open. I'm running again a 0.44 ohm dual coil at 20-21 watts
