Rda center posts turning

Status
Not open for further replies.

B2L

Vaping Master
ECF Veteran
Verified Member
Jan 14, 2012
7,844
45,313
Jacksonville, FL
It can definitely decrease performance, it can really screw up your coil as well as cause a short. I have an Igo W that does the same thing. Just be careful tightening down the positive screw and check your continuity before you fire it and you should be OK.

If mine gets out of place, I take a pair of needle nose pliers and twist it back into position.
 

B2L

Vaping Master
ECF Veteran
Verified Member
Jan 14, 2012
7,844
45,313
Jacksonville, FL
I've never had an issue with any topper other than the Igo, which is a lower end device. In my case I was the cause, I pressed the center post out to drill it and convert it to bottom feed. I never had that problem with it before.

Some center posts are threaded which eliminates the issue but any rda with a press fit post, theoretically, can have that problem.

I don't have a Nimbus, from what I hear they are a great atty, but I would guess it is press fit.
 
Status
Not open for further replies.

Users who are viewing this thread