Recommendations for new genesis RBA?

[zmauls]

Currently using my RSST, which I love, but I also like switching it up from time to time and this is the only rba I own.

I have two mech mods:

Smoktech Natural
Grand Vapor Private V2

Also, I re-drilled the air hole to 1/8 inch, which I think might be too big.

Anyone have any suggestions?

Thanks in advance.

 

[xxsteven69xx]

I have an Aga-t2. I've drilled the hole a little bigger and I like the options it offers. Also have a z-atty U and the RSST. I must say that the zenesis is my favorite but i find my self using the Aga-t2 more as parts are more easily available. I just got the stainless steel tank for my zenesis in case i break the glass one again I will have a back up no matter what. Both are way better than the RSST IMO. I use the RSST to test new builds in for the most part these days (Aka cotton, micro coils, diff mesh or ribbon vs round wire) I'm waiting for a kayfun to arive in the mail. Ill let you know if there is an improvement.

 

[K_Tech]

If it has to be a Genesis, give the Youde AGI a shot, it can be set up as an RBA/RDA, and it's not that bad for the money. I've only tried it as a dripper so far, and if I get some time soon I'll give it a shot in RBA mode.

 

[zmauls]

I have an Aga-t2. I've drilled the hole a little bigger and I like the options it offers. Also have a z-atty U and the RSST. I must say that the zenesis is my favorite but i find my self using the Aga-t2 more as parts are more easily available. I just got the stainless steel tank for my zenesis in case i break the glass one again I will have a back up no matter what. Both are way better than the RSST IMO. I use the RSST to test new builds in for the most part these days (Aka cotton, micro coils, diff mesh or ribbon vs round wire) I'm waiting for a kayfun to arive in the mail. Ill let you know if there is an improvement.

AGA-T2 looks great... What are the extra screws in the top half for?

Looks like the +/- connection is made through the middle column and the upright pillar.

Can't find a picture of it taken completely apart. Can the glass/pyrex (can't tell) tank be removed from the bottom half?

Looks like an easy go-to. Let me know, thanks!

 

[TylerWells]

Currently using my RSST, which I love, but I also like switching it up from time to time and this is the only RBA I own.

I have two mech mods:

Smoktech Natural
Grand Vapor Private V2

Also, I re-drilled the air hole to 1/8 inch, which I think might be too big.

Anyone have any suggestions?

Thanks in advance.

Go with the aga it's dope

 

[perldog007]

I'm on a clone budget. BUT!! the Steam Turbine clone I just got is sweet. If you don't like the cover on the tank you can run it without it. If I was in the market for an upscale high end genny I would be looking for a Steam Turbine from Doc.

 

[xxsteven69xx]

All the diff screws are for sillica, u wicks, filling, ect...... What ever you can imagine. I have only done one hole and used stainless steel and am running a micro coil with cotton right now. For the price level it is it has plenty of options and a lot of YouTube coverage to get some ideas flowing.