Recommendations on clearomizers

Status
Not open for further replies.

bic247

Senior Member
ECF Veteran
Feb 9, 2012
133
14
My room :P
I got one off LF's site a week or so ago and i love it! no worries about when to fill but i had several questions and i was wondering if anyone could help? the current one i have is i believe 2.5-2.9 ohms and its working very well. I tried using a carto last night with my other liquid and it just didnt feel right lol 1) Where could i get some great clearomizers? (recommended sites? prefer US ones maybe some cheap prices? BUT great quality as well)2) whats the best ohms to use on my battery? (750mah) unsure whats it voltage is :( 3) any maintenance tips for clearomizers? how could i clean and when should i? (i know it seems like a dumb question lol but just want to know, currently i been topping off when its gets low, i dont let it get to low, maybe thats bad? should i be refilling it with new liquid every so often?) Still a noob as it seems :blush: but getting there, also had 2 friends ask about where i got my PV and have pointed them towards this forum so happy about that, lots more to talk about! Thanks in advance! :vapor:
 

Smokin'Sandy

Super Member
ECF Veteran
Apr 28, 2009
400
45
Oklahoma City, OK/USA
I love the Ego Vision Clearomizer myself. I'm using a 2.2 - 2.5 ohms. I'm just using a regular Ego T battery...650mah. Rubber City Vapor is about the only place I can find them right now.

I just run a little water around the side to fill it up and swish it around a few times and I'm good to fill it back up. :D I do sometimes just fill it back up with some still in it, but it gets pretty dark when it gets too low, so I end up just dumping what little is left and then put the water in it. It may be bad, but I don't let it dry. I just fill it up with juice again and start puffing. It takes a little while to get it going, but it works fine after that.

Vision Ego Clearomizer
 
Last edited:

vikeme28

Super Member
ECF Veteran
Jan 16, 2012
578
572
Waste Lands
Volcano Clearomizer Power Flush and Dry Burn - Part 1 - YouTube
Volcano Clearomizer Power Flush and Dry Burn - Part 2 - YouTube
lots of great stuff on you tube, this hear is the best method that i use. I dont use a syringe to purge clean them though, I just warm up a bowl of distilled water in the microwave and rinse them out real good till the juice color is gone from the wicks and they are white again then i dry burn them. I get them from volcano and they are good quality. I have gone through 30 or 40 from them and have yet to have a defective one. fast shipping too considering they are in hawaii. as far as ohms anything above a 2.5 will work good on what you have. the ones from volcano are around 3.2
 

bic247

Senior Member
ECF Veteran
Feb 9, 2012
133
14
My room :P
okay i see now, but can anyone please point me to what type of ohm range would work great on my Riva SE that i have right now, its a 750mah battery and its 3.7v (Riva SE Carto Kit | Sweet-Vapes E-Liquid) <-link to where i got it and the info, i originally got the 1.7 ohm cartos and there great but i was wondering if anyone could give me a range of ohms that would work great without killing my battery (recently got paid and i wanted to shop a bit and stock up while i can) i would really appreciate it please? i know i was told that 2.0 ohm would work but i wanted to double check as i cant find that post anymore, and i was curious whats the recommended lowest to highest ohm ranges that i could use with the battery that i currently have? please help!! :unsure: ps-i was curious what the different ohms would do to my vaping experience? how does it differ?
 
Last edited:

vikeme28

Super Member
ECF Veteran
Jan 16, 2012
578
572
Waste Lands
IMO i think any ohm will work very good on what you have. I ran 3.2 ohm on an ego type 1000 mah battery and they were my everyday vape. You can run 1.5 to 3.2 no problem. going to be your preference on what to run based on what you like. the higher the ohm the less drain on the battery I think. a lot of people like the lower ohms because it creates a warmer vape. Honestly to me the "warmer" the vape just made things taste burnt a lot sooner and drained my battery a lot quicker. Unfortunately you are going to have to try on your own and find out what works for your preferences. again any ohm will work fine on what you have.
 

chinsk

Senior Member
ECF Veteran
Feb 7, 2012
195
87
I love the Ego Vision Clearomizer myself. I'm using a 2.2 - 2.5 ohms. I'm just using a regular Ego T battery...650mah. Rubber City Vapor is about the only place I can find them right now.

I just run a little water around the side to fill it up and swish it around a few times and I'm good to fill it back up. :D I do sometimes just fill it back up with some still in it, but it gets pretty dark when it gets too low, so I end up just dumping what little is left and then put the water in it. It may be bad, but I don't let it dry. I just fill it up with juice again and start puffing. It takes a little while to get it going, but it works fine after that.

Vision Ego Clearomizer

I have noticed that as well, the darkness at the end of a tank. Whats up with that? Is that burn from the wick darkening the liquid, or is it certain components of the juice evaporating/vaporizing out?
 

tj99959

ECF Guru
ECF Veteran
  • Aug 13, 2011
    15,116
    39,600
    utah
    All atties/cartos do that, it's just that you can see the darkening with a clear tank. It is just partially caramelized juice from the coil leaching back into the tank. With the Vision eGo (CE4+) just take the tip off, turn it upside down to drain, and then just fill it back up. I have put at least 100ml of juice through one of mine, and that is all I have done.

    I'll say it again: for the eGo-T/C lovers out there the Vision eGo (or what ever else a vendor wants to call it) is a win-win. Twice the performance for half the price.

    Now if you are expecting to compare it with a HH-357 sitting on top of a Kick or good VV mod and you like vaping at 10-11 watts, you would probably be disappointed.
     
    Last edited:
    Status
    Not open for further replies.

    Users who are viewing this thread