So I use an MVP ver 1.5 and I recently got an Evod to try out and I've noticed that when I screw it all the way down I get hardly any airflow. The Evod was fine on an ego battery, I also put on a 510 to ego adapter on my mvp then put the Evod on and it worked fine as well. So has anyone else had this problem?
- Status
I have 4 evods, and I don't screw them all the way down on my ego's or SVD. I screw them down just enough to make contact with the pin. I do have one evod that needs to be screwed on more than the others, but I don't know why. I'm very careful with that one and it has no writing on the base. Not sure if it's a knock off or what. The first evod I bought from one store has the kanger evod writing on the base, the 3 others I bought from another store don't have any writing on the base. Also, check the coil to see if it's clogged up or anything. Be carefull when putting a pipe cleaner down them or q-tips.
Nah it's nor clogged up for anything, it's a brand new coil, and mine has the Kangertech on the bottom. I don't screw mine all the way down on my MVP but even with that the airflow is still pretty horrible, idk why. May just be mine specifically lol
I've found this as well. One of my evod bases, the air holes are inside the threading and I get almost zero airflow on the MVP2. I'll be drilling some new holes eventually. On my other, the holes are above the threading, but still get a REALLY tight draw compared to putting it on an ego. I think it's just the way the ego connection is designed on the MVP.
Yeah your probably right, now that I take a look at the air holes I can see what your saying. It's a shame though, I have a black evod and MVP and they look so flawless together
Yeah your probably right, now that I take a look at the air holes I can see what your saying. It's a shame though, I have a black evod and MVP and they look so flawless together
I drilled out 2 holes on my Evod heads with a 1/16" drill it, and it made it much better. Before I drilled it, I was sucking so hard it was causing it to leak. It all depends on where the threads end up on the MVP threads. Once drilled, I can see the top of the MVP connection, about halfway through the hole. The draw is much improved, and no more leaks. Pic below.
Wow. I find the Evods a little too airy.
Just curious, are you removing the trim ring from the MVP? With it on, Ego devices like the Evod don't get much airflow.
Just curious, are you removing the trim ring from the MVP? With it on, Ego devices like the Evod don't get much airflow.
Na, I generally take it off when I put on something that's ego threaded. I personally prefer a more airy draw tbh
- Status
Similar threads
- Locked