So my ohm reader reads my build at .16 my Vaporshark at .14 and my sigelei 150 at .10 I'm sorry but that's a large difference! The ohm reader is a crappy one and I wouldn't really trust it to be really accurate that much. The Vaporshark has always consistently read my coils .02 lower than the ohm reader. Even on my Mutation X V-4 the same behavior is repeated. I work at a vape shop and the same behavior happened between 3 units... Any ideas?
Resistance on Sigelei 150 TC wonky...
- Thread starter Darkloud
- Start date
- th_trl_thread_readers 0
- Status
Just an idea... I know my Atlantis v.2 is way off unless I really crank it down on my Sig 150TC. It will read at .35 and then when I tighten it it reads at a (more accurate) .28.
I hear that Innoken has really accurate resistant chips on their VW/VV mods. Maybe give it a try if you have a demo unit at the shop?
I hear that Innoken has really accurate resistant chips on their VW/VV mods. Maybe give it a try if you have a demo unit at the shop?
Sounds to me like the sigelei is probably reading to closest to reality.
I wouldn't trust the meter in any APV, for anything more than for the calculations the device uses to adjust power output and general reference. Just like the idiot light and gauges of your car are NOT intended for diagnostic purposes, neither should the meter in your MOD.
- Status
Similar threads
