Rincoe Manto Max 228W Kit Three in one

Status
Not open for further replies.

Frenkyou

Ultra Member
ECF Veteran
  • Apr 26, 2019
    2,064
    2,186
    56
    italy
    www.svapo.it
    1.jpg


    Rincoe Manto Max 228W Kit Three in one.
    The question arises, is it possible to buy a powerful dual battery well-built mod that can work as Pod / rba, as Mod RTA and as RDTA for just over 20 euros? The answer is yes!

    Enjoy the reading.

    The packaging shows the front; the device, the color indication and some main features in the form of icons.

    On the back they are listed; packing list, warnings, scratch & check, QR-code, barcode, logos & brands.

    2.jpg


    On the side of the package there are; logos & brands, list of social platforms that Rincoe uses for its advertising.

    3.jpg


    Rincoe Manto Max 228W pod kit comes with:

    1 * Kit Manto Max 228W
    1 * 8ml cartridge
    1 * Single 0.3Ω Mesh Coil
    1 * Dual 0.2Ω Mesh Coil
    1 * USB charging cable
    1 * 510 Adapter
    1 * User Manual
    1 * Certificate Card
    1 * Warranty Card

    4.jpg


    Specifications Kit Manto Max 228W:
    Material: Zinc alloy
    Measurements: 40.3x37x111 mm
    Weight: 149gr
    Chip: Mechman (0.002s)
    PCB efficiency: 95%
    Screen: 0.96 color
    USB charging: 5V / 2A
    E-liquid capacity: 8ml
    Battery: Two 18650 (not included)
    Maximum output current: 40A
    Maximum output voltage: 8.4V
    Wattage range: 1-228W
    Input voltage: 6.0-8.4V
    Support Modes: VW, TC (NI200 / TI / SS)
    Resistance range supported in VW mode: 0.08-5.0ohm
    Resistance range supported in TC mode (NI / TI / SS): 0.05-3.5ohm
    TC range: 200-600 ℉ (100-315 ℃)
    Colors: Tarnish, Rainbow, black

    5.jpg


    6.jpg


    First impressions of Rincoe Manto Max 228W:
    The Manto Max 228W kit is built in sturdy zinc alloy, has a well-grip shape and is also light enough to carry. The feeling is immediate.

    The two main features that immediately struck me favorably are; the large liquid capacity (8ml) and the possibility of making a quick refill from above, without disassembling anything.

    In the package there is a very useful 510 adapter that allows you to install and use any Tank.

    But now let's find out more about this kit ...

    7.jpg


    The front is narrower and incorporates the control panel, the fire button has a shape similar to a light switch, can be easily reached with both the thumb and the index finger.

    Below the 0.96 "inch screen are the up / down buttons and the micro-usb charging socket.

    The triangular shape on the back is rounded and fits perfectly in the hand, on the side panels we see at the top the three fixed air intakes to feed the coil, these air intakes are excluded using the 510 adapter or the RDTA module.

    8.jpg


    9.jpg


    The compartment / pod has the bottom screwed to the battery by three torx screws, on the bottom in addition to the contact pins there are three magnets, two small circular ones and a larger one with an elongated shape, these magnets really have a great attractive force.

    On the bottom of the mod there are three torx screws, the battery compartment door has six vent holes and can be opened by sliding, internally it has the polarity indications marked on it. When you open it, the door dances a lot, but once the batteries are inserted and closed there is no inaccuracy or abnormal movement.

    10.jpg
     

    Frenkyou

    Ultra Member
    ECF Veteran
  • Apr 26, 2019
    2,064
    2,186
    56
    italy
    www.svapo.it
    The cartridge is built in food-grade PCTG and is perfectly transparent, it really contains a lot of (8ml) liquid, unfortunately the Tip is integral with the structure and is not replaceable.

    The bottom of the cartridge has three magnets that mirror those in the compartment / pod.
    The rubber cap, once lifted, leaves free a refill slot of optimal dimensions.
    The coils are inserted into the cartridge with the press and pull method. We can choose to install three types of coils or the regenerable RBA (optional).

    11.jpg


    12.jpg


    Vaping with the Coils included in the package:

    - The 0.3Ω Single Mesh coil has a range of use between 50 and 70W, already at the minimum recommended wattage the performance is impressive and the delivery is very reactive, by pressing the magic button the tip shoots some frightening clouds!

    The heat transmitted by the steam at 50W is low, increasing the power to 60W (MAX) the heat increases but it is never annoying, my red fruit aroma reaches its maximum and the clouds produced are embarrassing, my cat got scared! I have to open the window!

    - The 0.2Ω Dual Mesh coil has a range of use between 60 and 75W, this gigantic Coil has a lot of cotton, of course it took a little longer to prime the liquid; I recommend to wet it well and wait at least 10-15 minutes before starting to vape.

    The reactivity characteristics also belong to this Coil, it starts well already at 60W, moving to 70W the steam is hot and the fog rises rapidly, invading the whole room.
    If the previous coil was worth a grade 9 on a scale of 1 to 10 ... this is worth 10!

    A pleasant surprise when using the prefabricated heads was to notice a practically absent condensation production, this is a typical problem of pod systems, but not of the Manto Max. Brava Rincoe! You have really made some very good Coils!

    13.jpg


    The 510 adapter present in the box, allows you to use practically any RTA / RDA tank, the 510 thread is placed in a slightly raised area this area has a perfect design for 25mm atomizers, however you can install atomizers up to 30mm in diameter without any protrusion compared to the mod.

    The 510 adapter is also equipped with strong magnets and is sufficiently fixed and solid once installed on the Mod, the pin of this 510 adapter is floating.

    14.jpg


    Manto Max RDTA module (available separately):

    In the box of this RDTA module you will find some spare deck screws and some o'ring, the deck and the tank are always 8ml (like the pod).
    To transport the liquid to the coil, Rincoe did not consider it appropriate to use the Ropes, so it will be the cotton that feeds the coils directly.

    15.jpg


    This RDTA essentially consists of four pieces:
    The Tip in derlin is gigantic, rather low and of type 810, without o-rings.

    The removable Top-cap adopts two o'ring, one for the tip and one for sealing, by rotating it, on the outer sleeve two opposing AFC slots of 6x3mm are discovered, the air through these slots can be directed parallel to the coils at any angle.

    Also on the outer sleeve there are two other AFC slots at the bottom that feed two small opposing holes (4 channels in total) of 0.8mm, the air is then channeled from the base of the deck directly under the coils, this is a really system interesting combined with the classic AFC placed at the top.

    The transparent cartridge follows the design of the original cartridge and has the same liquid capacity (8ml). The bottom of the cartridge is sealed, so there are no leaks of any kind.

    The Deck has two really giant slots for positioning the cotton, which is why I chose to make two 3mm diameter coils, so I made two 24ga Ka1 coils, the final resistance turned out to be 0.3Ω.

    16.jpg


    RDTA Vape Test:
    This RDTA certainly offers truly exceptional air regulation thanks to the double AFC system. Using only the higher AFCs, the performance is the classic one of a normal RDA with the air flow directed laterally on the coils, while using only the lower channels the puff takes on a completely different appearance, the shot is rather closed, dark and silent, with a big blow in the throat, the direct air flow under the coils transmits a very good and rather warm aroma. Of course, using both configurations the Puff becomes very open and profitable for the DL puff, also suitable for quite powerful coils.

    The build I used at 40W combines very well with the exclusive use of the lower AFC, I enjoy vaping like this, the Puff is hot, the hit strong, sometimes I open the upper afc slightly to relax my throat and to make some nice clouds!

    The build is really simple to perform, the cotton whiskers lowered into the slots perfectly transport the liquid to the coils until the last drop ... I really have to congratulate Rincoe for this brilliant RDTA module! I highly recommend you buy this option, you will be satisfied.

    17.jpg


    Mod Operation:
    The Manto Max is powered by two external 18650 batteries, it provides an adjustable power from 1 to 228W. Its performance is stable, the MECHMAN Chip has a good fire rate of just 0.002 seconds. The 0.96 inch color screen shows useful information, battery level, ohms, volts, watts, last puff duration and available colors.

    - It takes 5 clicks on the Fire button to turn the mod on / off
    - Three clicks to enter the menu, we can choose the modes: VW, NI, TI, SS.
    - By installing a new atomizer (TC mode) the writing old / new coil appears on the screen, then select with the up / down keys and confirm with the Fire key
    - By pressing the Up / Fire keys at the same time, we can select one of the six background colors with the Up / down keys, confirm with the Fire key.
    - To lock the screen, press the up / down keys simultaneously.

    18.jpg


    Multiple protections:
    Overheat, battery reverse, overcharge, short circuit, 10s cut-off, low voltage protection.

    19.jpg


    Final remarks:
    The kit really offers many Vaping options, quickly switching from one module to another, namely: from our favorite atomizer, to a pod system equipped with huge durable heads and with excellent aromatic yield (3 + RBA) to a really well RDTA system realized. The magnets are really strong, securely holding the pod or whatever module we are using.

    Note * The 510 adapter comes in the box while the RBA and RDTA decks are available as separate purchases.

    Pro
    Mod with Smart and portable Design
    Well built kit
    Chipset with a fair amount of functions
    Colorful and bright Shermo Oled
    Choice of Mesh Coil, single, dual, triple
    Mesh Coil with good aromatic yield + incredible clouds
    510 adapter present in the package
    RBA Optional for the original pod
    RDTA System Optional Ultra adjustable and well crafted
    Tank Pod and RDTA tank with 8ml of capacity
    Comfortable upper refil
    Great price

    Tips
    No AFC control with the original pod

    Thanks Sourcemore for sending me these kits for review:
    Rincoe Manto Max 228W Kit 8ml pod mod kit dual 18650
    Rincoe Manto Max RDTA Pod Cartridge 1pc

    20.jpg
     
    Status
    Not open for further replies.

    Users who are viewing this thread