I drilled the air hole on my rm2 to 1/16 and I wished I didn't. Can I just buy a new top cap? What size are the screws for the rm2? Thanks ,Dave
Rm2 top cap and screw question
- Thread starter spada
- Start date
- th_trl_thread_readers 0
- Status
You can purchase both top caps and screws from Rob, just PM him.
In the meantime, a piece of tape over the hole pierced to what ever size you prefer will keep you vaping for now.
In the meantime, a piece of tape over the hole pierced to what ever size you prefer will keep you vaping for now.
Shoot Rob a pm, he can hook you up. Just for future reference though you can get the Triangle atty from Empire mods. It is the same atty that Rob modifies into the RM2. You would have to drill the hole in the cap though. Triangle Stainless Steel Rebuildable Atomizer
Screws are m2x4mm and yes PM Rob he will sell you a new top cap. But if you haven't already, give it a few days. when I changed my air hole it took a few days to adjust. Try building a slightly lower ohm coil, you'll get back the heat and probably produce more vapor.
+1 on FB's advice... I drilled my cyclone to 1/16th and immediately regretted it. When I got home, I built a coil that was lower than what I had (I think I went from .8ohms to .6 or something) and the flavor was back and the vapor was more abundant..I got used to the draw and now prefer it. Took me a little while, though.
I still love my 3/64 intake in you no whats great about not using large air holes at super low ohm slight pause my batteries last longer and my mod never ever has problems . The larger the air intake the lower in ohm you have to go to get back to were you started . Its a slippery slope one has to no when its time to say ok this is enough . 1/16 intake not bad for a intake I see some people using holes I could park my truck in. I ask myself why do they even bother using the dam cap just huff over it like a junky no need for drip tips or a cap bonus
I've never been one to experiment with something that is already perfect to me. 
If enlarging the air intake makes it any better.......I'd have to slap myself.
If enlarging the air intake makes it any better.......I'd have to slap myself.
You don't have to do it yourself your friends in Reoville are here to lend a helping hand.I've never been one to experiment with something that is already perfect to me.
You don't have to do it yourself your friends in Reoville are here to lend a helping hand.
I'm getting that warm and fuzzy feeling again. The reo people are simple second to none as far as I am concerned. You are talking about drilling the intake and not slapping me, right? Just kidding.
- Status
