rocket fill port

Status
Not open for further replies.

YMe1121

Senior Member
ECF Veteran
Verified Member
Mar 14, 2013
92
48
35
usa
is there a trick to the fill port, i have tried using a large needle, and a small needle to try and fill it, but all that happens is i get juice all over the bottom of it as it comes back out... i hold it upside down, but to no good... so is there a trick behind it or should i just stick with top feeding it.

so to recap..
i take out fill screw
hold upside down
juice doesnt go into tank....
 

tfnc

Super Member
ECF Veteran
Verified Member
Aug 7, 2013
875
696
arkansas
Fill port is useless. Take top cap off,fill tank up. Screw Top on just barely.Cover air hole with finger. Turn rocket upside down.Tighten up top.If you get flooded try taking a drag using the air hole on the side.It should use juice in chamber without drawing in more juice. Lots videos on u tube on how to do this with the kayfun.
 

jakelov

Full Member
Dec 28, 2012
13
0
NM
and do you know of a way to stop it from whistling? i have figured it is coming from the air flow adjustment hole, not the actual air hole itself, but i dont know if the size of the hex screw is too smal, so air gets around it, or what the cause is, but i know that if i block it off, it stops whistling
I stuffed a little piece of a straw from a wd40 can in the air hole. Maybe an 1/8th of an inch. Leave a little bit of the straw sticking out then just shave it flush with a razor blade. You may have to open the straw up a little after you shave it. I just stuck a pin in it in a circular motion. Open up air control screw all the way and vape away! Now the dog wont think youre calling him every time you take a drag!
 
Status
Not open for further replies.

Users who are viewing this thread