Screw for adjusting air flow - Kafun lite clone

[oplholik]

Mine has the one air hole, and the adjusting screw has gone missing. Can I order some somewhere?
Worst case, I will try plugging off one hole in one of the two holers I have, and using one of those screws.

 

[cobalt327]

I had the same problem. It seems there are at least two different sizes used depending on the manufacturer, at least that's what I read. What I ended up doing was sifting through my smallest hardware until I found a screw that had the right threads. I then used a dremel to cut off a piece a little less than 1/8". The hard part was thinning a Dremel p/n 409 emery cut-off wheel to slot one end for a flat blade screwdriver.

If you're lucky, FT SKU 2056700 will have the right set screw.

 

[oplholik]

Thanks cobalt. I believe this particular clone came from FT, so might get a couple of those to have.

 

[cobalt327]

You're welcome. There's some info in the Discussion section that may mean this isn't a good set of parts. Take a look: https://www.fasttech.com/forums/2056700/t/1597531/screw-is-more-big

 

[oplholik]

Hmm, mine looks like it would be the smaller of the two. Thanks for digging that up.