Second attempt at a parallel coil

[BagrX2]

So this is my second attempt at a parallel coil as the title says. It is 5 wraps around a 3mm screwdriver with 26 gauge wire. It is sitting at .16 ohms. I think it puts out like a champ and nearly zero ramp time.

 

[sacullen]

Isn't that resistance a bit low for a series box?

 

[BagrX2]

Isn't that resistance a bit low for a series box?

You are right, it's a bit low. I usually build .25 or so, a little more or less. I figure As long as I dont go crazy with the voltage the chip should take it. I was actually way to high there. I should be around 4 volts or a little under with the raptor. I have never been able to fin a true lowest resistance it coud take. I just build around its voltage and amp limits.