Shipments Arrived! One question

[feverrave]

everything arrived save and sound
Dse901 auto and manual
extra atomizer
120 carts
Brandy, DK-TAB, Blueberry, Vanilla, 5*5, RY4, Chunghwa

^ fave would probaly be blueberry, and 5*5.
RY4 is very similar to the dk-tab... i think anyway

Chunghwa has a plasticy taste to it.

QUESTION
There is a white residue/ burn? Inside the shell of my atty. it goes from where the cart connects, down.
tried whiping with a Q-tip, will not come off.
and there is a bit of a burnt smell.

what is this?

 

[drac]

Just a guess and I home someone will give you a better answer. The atty's are shipped with a protective oil like covering on them. That is what gives a new atty that horrible taste until it burns off. Maybe that is the residue from the protective film.
Drac

 

[feverrave]

hhmmm...i blew out all the factory lube before using the attys , but i guess if there was a coating inside of that or some chemical could be it?

 

[mopar]

Flood with juice burn it off and swap carts. Flavour will be norm after that.

 

[feverrave]

flood with juice? the atomizer? isnt that bad?
haha, sorry i need more details still a noob here...

 

[akira712]

where did u order from?

 

[kanadiankat]

flood with juice? the atomizer? isnt that bad?
haha, sorry i need more details still a noob here...

Depending on the battery. If you're using an auto battery - don't flood it with juice. Remove the atty - rinse the inside thoroughly with Vodka, then put a drop of your fave liquid on the atty bridge - screw it in and use as normal. This should take any shipping fluid off.

If you're using a manual battery - flooding the atty shouldn't be a big problem. Just put 5 or so drops of liquid directly into the atty and press the manual button. Sometimes it helps if you take short fast puffs on the atty (without a cartridge attached) when you're doing this.

Also - a couple drops of straight VG on the bridge after a vodka wash makes your atty very happy (and a happy atty is a healthy atty).

 

[mopar]

flood with juice? the atomizer? isnt that bad?
haha, sorry i need more details still a noob here...

Like kat said

 

[sam.8]

Congrats and good luck!!

 

[Danesnpits]

hhmmm...i blew out all the factory lube before using the attys , but i guess if there was a coating inside of that or some chemical could be it?

I am thinking you just need to break in the atty. It should go away fine!!

 

[Pipeous]

I would try and wash that out. white residue would scare me. the primer they put on an atty is clear.

 

[DaveP]

I normally blow out a new atty from the large end into the sink. I generally get a couple of large drops of clear primer. After that, I prime the bridge (mesh) with a couple of drops of juice, fill a cart and vape. If you got white powder residue, that's not what most of us see. It's on the inside of the barrel? I'd try another atty and see what happens. As others said, you can wash the first one out with Vodka or 91% isopropyl alcohol, dry it and vape.

 

[mopar]

White powder? Anthrax?