RDA Shorting problem with Poseidon Shorting Help

[JT!]

It reads 0.3 on my ohm meter (multimeter).

As I screw it on to my subox, it reads 9.9, when it gets to a certain point, it reads 0.0.

Sometimes if i get it in the sweet spot it'll read 0.3 and will actually fire for a second or so then it'll tell me it's shorted by flashing 0.0

Other rda works fine on it.

Help!

 

[State O' Flux]

Check the atty positive post. Is the post head (510 positive) being pushed, laterally, into, and making contact with the atty body (510 negative)... when screwed and snugged into the mod?
I've seen a few clone Poseidon V3s where the positive post head is only a few thousands smaller OD than the negative bore ID... and it wouldn't take much of a push to short one out.

 

[JT!]

It's pretty close, and not insulated all the way up like my mutation x clone is. But it's hard to tell if that's the issue.

 

[JT!]

Actually I'm going to say this isn't the issue. Managed to wrap some electrical tape around the edge of the adjustable screw and the issue persists.

 

[JT!]

Urgh, I guess it was too low ohm and the subox was stopping it from firing. Clipped out one of the 4 coils and runs fine with 3 at .3 ohms. Noob error.