sigelei 150 adjustable post?

[nipseyrussell]

i have a sigelei 150 and when i put attys on it, the logos never face the front, they go just past like they are screwing on too far
i see the 510 pin doesnt have a screwable head, but is there any way to adjust it "up" a little so the attys dont screw down as far?

 

[classwife]

moved to Variable Voltage APV Discussion

 

[EverPresentNoob]

I believe it is spring loaded, at least my 100+ was. if so just get a rubber O ring and put that under your atty. Look in the boxes your attys came in, I bet you have spares in there that will work just fine. as long as you dont need much room to get that label facing where you want this should work just fine.

 

[roxynoodle]

It is spring loaded so don't try to adjust it. The o ring idea is a good one.

 

[nipseyrussell]

OK, thanks. Tried an o-ring but it seems like exchanging one aesthetic problem for another!

 

[coilburner]

Nobody's logos on any tanks ever face the "front". You screw it on and it stops turning when it stops turning. I didn't know people had issues with this, or should I say that it would even be an issue.

 

[nipseyrussell]

Fair enough, I'm in this to quit smoking not look cool, but it would be nice if all this equipment lived up to its aesthetic potential!

but on another note, when held in the most ergonomically correct way, on at least one atty the air hole is right up against my chin or lip - That stuffs hot when it comes out!