So as the title says i have an AGA-T+, and there are small issues, the center nuts on it are horribly threaded and barely catch the center screw and for the most part turn without ever catching, and i received it this way. They work well enough that when i have a wire in place and the nut is at an angle the threads will catch and tighten down but as time has progressed over the last couple months and i have been rebuilding the coils it's obviously starting to loosen more readily and cause my ohms to start jumping thus facilitating the need to open it up tighten it down and adjust etc.
Anyone have a suggestion for a fix? I've considered finding a threaded screw and nuts to replace the centerpost and top nuts.The only problem is that then i will have to modd the nuts and screw head to fit as the center post, which isn't necessarily a no go but filing down the nuts will be a major pain.
Also any suggestions on other rba's with slightly better build quality? (keep price in mind please I have a 9 week old and funds are tighter than they used to be)
my main PV is a provari with the AGA-T+, and before that it was a lavatube and DCTank that died. I obviously still have the DCT's still laying around as backups in case something happens to the rba.
many thanks,
Sniff
Anyone have a suggestion for a fix? I've considered finding a threaded screw and nuts to replace the centerpost and top nuts.The only problem is that then i will have to modd the nuts and screw head to fit as the center post, which isn't necessarily a no go but filing down the nuts will be a major pain.
Also any suggestions on other rba's with slightly better build quality? (keep price in mind please I have a 9 week old and funds are tighter than they used to be)
my main PV is a provari with the AGA-T+, and before that it was a lavatube and DCTank that died. I obviously still have the DCT's still laying around as backups in case something happens to the rba.
many thanks,
Sniff