AGA-T2 issue with center pin

[zipflint]

Hey, that'll do in a pinch! Never woulda thunk of that.
For real.

I have used heat shrink tube on a few atties and it lasted months; never failed. Can double tube to make pin protrude to eliminate chance of hard short on some mods. I heat tube then trim excess w/ razor. Of course heat shrink won't function as a seal so not good for all applications.

I would like a source for UD hot pin o-rings as well?

 

[emus]

I should have remembered KP has:
AGA Series Positive Post Insulators - 10 pack - Kidney Puncher

 

[zipflint]

Oh I knew about those. But aren't those for the TOP of the positive post?
I need the little simple round o-ring that fits around the bottom of the 510 connector, just above where
the atty meets the mod.

I should have remembered KP has:
AGA Series Positive Post Insulators - 10 pack - Kidney Puncher

 

[emus]

Was wondering the same thing. I skimmed all the reviews and saw no complaints it wouldn't work on bottom. I've got tons of UD toppers but it's been awhile since I had a pin out. None of my UD toppers have failed yet. I'll snag a set next KP order just in case. They will probably work on some of my junky FT toppers but I haven't used them in a while.

 

[pdib]

I should have remembered KP has:
AGA Series Positive Post Insulators - 10 pack - Kidney Puncher

Oh I knew about those. But aren't those for the TOP of the positive post?
I need the little simple round o-ring that fits around the bottom of the 510 connector, just above where
the atty meets the mod.

oh. That's what I always used to use top or bottom.

 

[Slobalt7]

Same here, mine came brand new with those top and bottom...

 

[zipflint]

Derp!
Well then, I guess my problems are solved.